Dell Precision M3580 Owner's Manual page 141

Table 44. System setup options—Security menu (continued)
Security
Authenticated BIOS Interface
Enable Authenticated BIOS Interface
Clear Certificate Store
Firmware Device Tamper Detection
Clear Firmware Device Tamper Detection
Table 45. System setup options—Passwords menu
Passwords
Admin Password
System Password
M.2 PCIe SSD-1
M.2 PCIe SSD-2
Password Configuration
Upper Case Letter
Lower Case Letter
Digit
Special Character
Minimum Characters
Password Bypass
Password Changes
Enable Non-Admin Password Changes
Admin Setup Lockout
Enable Admin Setup Lockout
Master Password Lockout
Enable Master Password Lockout
140 BIOS Setup
By default, this option is disabled.
By default, this option is disabled.
Enables you to control the firmware device tamper detection feature. This
feature notifies the user when the firmware device is tampered. When enabled,
a screen warning messages are displayed on the computer and a tamper
detection event is logged in the BIOS Events log. The computer fails to reboot
until the event is cleared.
By default, the Firmware Device Tamper Detection option is set to Silent.
For additional security, Dell Technologies recommends keeping the Firmware
Device Tamper Detection option enabled.
By default, this option is disabled.
Set, change, or delete the administrator password.
Set, change, or delete the computer password.
Set, change, or delete the SSD-1 password.
Set, change, or delete the SSD-2 password.
Reinforces password must have at least one upper case letter.
By default, the option is disabled.
Reinforces password must have at least one lower case letter.
By default, the option is disabled.
Reinforces password must have at least one digit.
By default, the option is disabled.
Reinforces password must have at least one special character.
By default, the option is disabled.
Set the minimum characters allowed for password.
When enabled, this always prompts for computer and internal hard drive
passwords when powered on from the off state.
By default, the Disabled option is enabled.
Enable or disable to change computer and hard drive password without the
need for admin password.
By default, the option is enabled.
Enables administrators control over how their users can or cannot access BIOS
setup.
By default, the option is disabled.
When enabled, this will disable the master password support.