General Features; Electrical Connection - DèLonghi TRN0808M Instructions Manual

GB
IMPORTANT: Do not cover the appliance during functioning, this could
cause a dangerous temperature increase of the radiator.

1. GENERAL FEATURES

Remove the appliance from the packaging, turn upside down and rest on the polystyrene.
Check that neither the appliance nor the power cable has been damaged in any way
during transportation.
Do not operate the appliance if damaged

2. ELECTRICAL CONNECTION

- Before plugging the radiator into the mains, check that the voltage of your mains elec-
tricity supply corresponds to the value V indicated on the appliance and that the socket
and power line are appropriately dimensioned.
- CONNECT THE RADIATOR TO EFFICIENTLY EARTHED SOCKETS ONLY
- This appliance complies with EEC Directive 89/336 and D.M. 476/92, relating to elec-
tromagnetic compatibility.
3. INSTRUCTIONS FOR USE
Switching on
Plug into the mains socket. Turn the thermostat to maximum. Switch the radiator on using
the switch/switches following the procedures given in points a) - b).
a) Models with single switch (1 power level):
- button in position «I» = Total power on (indicator light on);
- button in position «O» = (indicator light off)
b) Models with double switch (3 power levels)
- button in position «l» = minimum power (indicator light on);
- button in position «ll» = intermediate power (indicator light on);
- both buttons in position «l» «ll» = maximum power (indicator lights on)
To turn appliance off, switch off both switches or remove plug from wall socket.
Adjusting the thermostat
When the room has reached the required temperature, slowly turn the thermostat until the
indicator light goes off (or to the position marked by a click) and no further. The set tempe-
rature will then be regulated automatically and kept constant by the thermostat.
Frost protection function
With the thermostat in position
at a temperature of about 5˚C, preventing freezing with minimum energy consumption.
c) Models with a 24 hour time-clock (fig. 1)
To programme heating, proceed as follows:
- Look at the time on your clock or watch. If it is 10.00, turn the numbered timer disk
clockwise until the number 10 on the disk coincides with the pointer
Set the periods of time when you want the appliance to work by pushing the teeth
inwards. Each tooth corresponds to a period of 15 minutes. This will leave visible sec-
tors which correspond to the periods of operation. When set, the radiator will operate
automatically each day during the times programmed (important: the radiator must
always be plugged into the socket).
- To change the programming, move the teeth back into the initial position and set the
new periods of functioning.
- If you want to make the appliance operate without programming, push all the teeth into the
centre. In this case, to turn the appliance off completely, as well as turning the switches
off, you must also unplug it from the mains to avoid continued operation of the timer.
*
and the switches pressed, the appliance maintains the room
on the timer.
5