Table of Contents
Advertisement
●
before servicing
●
before clearing a blockage
●
before checking, cleaning, and working on the
product
●
before changing accessories
●
after striking a foreign object
–
Inspect the blades for damage, and make repairs
before restarting and operating the product.
●
before leaving the product unattended
●
before performing maintenance
●
whenever the product starts to vibrate abnormally
–
Check the product immediately.
■
Injuries may be caused, or aggravated, by prolonged
use of a tool. When using any tool for prolonged periods,
ensure to take regular breaks.
■
Operate the product only in temperatures between 0 °C
and 40 °C.
■
Store the product in a location where the ambient
temperature is between 0 °C and 40 °C.
ADDITIONAL SAFETY WARNINGS
■
Some regions have regulations that restrict the use of
the product. Check with your local authority for advice.
■
Avoid using the product in bad weather especially if
there is a risk of lightning.
■
Avoid using the product on wet grass.
■
Hearing protection may restrict the operator's ability
to hear warning sounds. Pay particular attention to
potential hazards around and inside the working area.
ADDITIONAL BATTERY SAFETY WARNINGS
■
To reduce the risk of fire, personal injury, and product
damage due to a short circuit, never immerse the
product, battery pack, or charger in fluid or allow fluid
to flow inside them. Corrosive or conductive fluids, such
as seawater, certain industrial chemicals, and bleach
or bleach-containing products, etc., can cause a short
circuit.
■
Charge the battery pack in a location where the ambient
temperature is between 10 °C and 38 °C.
■
Store the battery pack in a location where the ambient
temperature is between 0 °C and 40 °C.
■
Use the battery pack in a location where the ambient
temperature is between 0 °C and 40 °C.
OVERLOAD PROTECTION
RYOBI 18 V lithium-ion batteries are designed with features
that protect the lithium-ion cells and maximise battery life.
If the product stops during use, the following may be the
causes:
■
The maximum current draw of the battery pack has been
exceeded, causing it to automatically stop powering the
product. Release the trigger to reset the product, and
pull the trigger to resume operation.
■
Excessive temperatures cause the battery pack to stop
powering the product. If the battery pack is too warm,
allow it to cool down.
4
Original Instructions
TRANSPORTATION AND STORAGE
■
Turn off the product, remove the battery pack, and allow
both to cool down before storing or transporting.
■
Remove all foreign materials from the product.
■
Check all nuts, bolts, and screws before each use and
at frequent intervals for proper tightness to ensure that
the product is in safe working condition. Any part that is
damaged should be properly repaired or replaced by an
authorised service centre.
■
Do not store or transport the product with the battery
pack installed. Remove the battery pack, and secure it
separately. Store the product in a cool, dry, and well-
ventilated place that is inaccessible to children. Keep
the product away from corrosive agents, such as garden
chemicals and de-icing salts. Do not store the product
outdoors.
■
For transportation in vehicles, secure the product
against movement or falling to prevent injury to persons
or damage to the product.
TRANSPORTING LITHIUM BATTERIES
■
Transport the battery pack in accordance with local and
national provisions and regulations.
■
Follow all special requirements on packaging and
labelling when transporting batteries by a third party.
Ensure that no batteries can come in contact with other
batteries or conductive materials while in transport by
protecting exposed connectors with insulating, non-
conductive caps or tape. Do not transport batteries
that are cracked or leaking. Check with the forwarding
company for further advice.
MAINTENANCE
■
Use only original manufacturer's replacement parts,
accessories, and attachments. Failure to do so can cause
possible injury, can contribute to poor performance, and
may void your warranty.
■
Servicing requires extreme care and knowledge
and should be performed only by a qualified service
technician. Have the product serviced by an authorised
service centre only. When servicing, use only original
replacement parts.
■
Turn off the product and remove the battery pack before
conducting any maintenance or cleaning work.
■
You may make adjustments and repairs described in this
manual. For other repairs, contact an authorised service
centre.
■
After each use, clean the product with a soft, dry cloth.
Any part that is damaged should be properly repaired or
replaced by an authorised service centre.
■
Check all nuts, bolts, and screws before each use and
at frequent intervals for proper tightness to ensure that
the product is in safe working condition. Any part that is
damaged should be properly repaired or replaced by an
authorised service centre.
■
Bring the product to an authorised service centre to
replace damaged or unreadable labels.
Advertisement
Table of Contents
