Kenmore DS6001 Use & Care Manual page 9

WARNING
Do not operate vacuum cleaner without
filter in place.
Before vacuuming, check that the brush
powerhead wheels and brush roll are clear
from any sharp objects to avoid scratching
floors.
Use low speed for surface cleaning of bare
floors or low pile rugs and carpets or when
increased runtime is needed.
Use high speed for cleaning of plush rugs
and carpets or when additional cleaning
power is required.
CLEANING WITH THE HAND VACUUM
1. To remove the
hand vacuum, press
the release button
and detach the hand
vacuum from the
main body.
2. To turn on the hand vacuum, press the
power switch located on top of the handle.
NOTE: When battery power is low, the
battery charge indicator around the switch
will flash.
To charge, place the hand vacuum into the
main body and place the whole unit onto
the charger base.
USING YOUR VACUUM CLEANER
1. To start the vacuum, slide the power
switch to the desired speed position
(Low Speed, High Speed).
2. To stop the vacuum, place the power
switch in (OFF) position.
(OFF) (Low Speed)
Power Button
3. To clean difficult to reach areas, use
the combination tool by inserting end of
combination tool into the hand vacuum as
shown.
- 9 -
(High Speed)