Sony KV-27V10 Service Manual page 31

(3) Dynamic Convergence Circuit Adjustment
SERVICE MODE PROCEDURE
1. Standby mode.(Power off)
2. [DISPLAY]~[5]>-[VOL (+)|-[POWER] on the
Remote Commander. (Press each button within a
second.)
SERVICE ADJUSTMENT MODE IN
Disp. Item
(Item) data
SERVICE AFC 0
1000 0000
2
The CRT displays the item Being adjusted.
. Press i] or |4J on the Remote Commander to select
the item.
5. Press [3] or [6] on the Remote Commander to
change the data.
6. Press |MUTING| then [ENTER) to write into
memory.
»
SERVICE ADJUSTMENT MODE MEMORY
IMUTING] Green
SERVICE WRITE T
1000 0000
ENTER) Red
7. Press[§] then [ENTER] on the Remote Commander
to initlalize.
SERVICE RESET
1000 0000
Factory original setting
8. Turn set off and on to exit.
* Set to Service Mode.
+ Input a cross-hatch signal.
KV-27V10/27V15
RM-Y117 RM-Y121/RM-CM101
KV-29V10C/29V10M/32V15
RM-Y117 RM-Y117 RM-Y121
RM-CM10
° Press i and 4 serect an item of adjustments.
° Adjust Bl and (6) to the best picture.
No. | Disp. Item Ave.Data
40 | UYBO | Upper Y-Bow 31
41 |LYBO | Lower Y-Bow 25
42 | HAMP | H. Amp 33
43 |HTIL | H. Tilt 33
44 | UCBO | Upper C-Bow 38
45 | UTIL | Upper Tilt 40
46 | LCBO | Lower C-Bow 41
47 | LTIL Lower Tilt 46
48 |DCSH | DC Shift 37
U. YBOW
Select UYBO with [I] and
"LH
\
i.
=
AMP
Select HAMP with [1] and [4]
a-(01
1