Bosch TASSIMO TAS 55 GH Series Instruction Manual page 20

18
Problem
Drink size smaller than
usual.
More steam than usual.
The appliance does not
recognise the inserted
T DISC and remains in
stand­by mode or the
F
Status LED lights up
red.
The quality of the foam /
crema has deteriorated.
Brewing unit cannot be
securely closed.
Brewing unit cannot be
opened.
Robert Bosch Hausgeräte GmbH
TAS55_GB-CH.indb 18
Possible cause
Not enough water in the
water tank.
The appliance needs
descaling.
The appliance needs
descaling.
Appliance is not switched
on.
No T DISC inserted.
The barcode could not be
detected.
The brewing system is
not properly closed.
The drink outlet is
clogged or dirty.
The appliance needs
descaling.
T DISC Piercing unit
or T DISC holder is not
properly inserted.
The T DISC is not in­
serted properly.
The brewing unit is not
properly closed.
The brewing unit is still
locked.
Solution
Fill the water tank after the drink
has finished dispensing and press
the start / stop button to finish the
drink.
Descale the appliance (for details
see "Descaling").
Descale the appliance (for details
see "Descaling").
Make sure the appliance is
switched on before inserting a
T DISC.
Check if T DISC has been inserted.
Clean the T DISC barcode reading
window and try again or smooth
the barcode on the T DISC out with
your thumb.
Use another T DISC.
If problems persist contact the
TASSIMO careline
08 00 032 88 33 (UK only)
Clean the brewing system thor­
oughly, especially in the area of the
clamp.
Remove the drink outlet from the
brewing unit and detach the pierc­
ing unit. After cleaning everything
thoroughly, reassemble the parts
and replace them in the brewing
unit.
Clean the brewing unit with the
Service T DISC.
Descale the appliance (for details
see "Descaling").
Insert T DISC holder or T DISC
piercing unit properly.
Re­insert the T DISC and make
sure it is properly positioned.
Push the handle down until it snaps
into place with an audible click.
Clean the brewing system
thoroughly, especially in the area of
the clamp.
Wait until the Status LED
stopped blinking before attempting
to open the brewing unit.
en
F
has
06.02.2012 15:06:18