Removals And Installations; Pcb Removal And Installation; Frontplate And Handle Removal And Installation - Panasonic JU-475-4 Service Manual

PART. ll
12. REMOVALS AND INSTALLATIONS
12.1 PCB Removal and Installation |
A E Caution of the cable leading
(1) Remove the four shield plate mounting screws
and take out the shield plate.
(2) Remove the one PCB mounting screw. Let the cable pass under the C guide. Hook the cable to the
(3) Disconnect the connectors (J3 CON, J4 CON, J5 rib projected on the
CON, 17 CON, J8 CON) from the PCB.
(4) To reinstall, reverse the above procedure.
(5) Readjustment is not necessary after PCB ía ' 60 The cable shall not
the drive. (Make it
flat by pressing
with a finger.)
Do not let the pig
tail bitten or
disconnected.
Do not damage or
disconnect the pig
tail by pressing it
forcibly into the
much in the PCB.
Fig. 12-1-2 Cable Leading
12.2 FrontPlate and Handle Removal and
Installation
| `
U |
y
li
li
Í fire
| +
U
(1) Operate the lock cam of the clamp assembly,
and turn the clamp handle in the direction of
clamping.
(2) Remove the clamp handle.
(3) Remove the two front plate mounting screws,
and take off the front plate.
(4) Reverse the above procedure to reinstall.
Lock Cam
Fig. 12-1 PCB Removal
Clamp Handle
Fig. 12-2 Front Plate and Handle Removal
-14-