LG V5RT9 Owner's Manual page 18

INSTALLATION
18
NOTE
How to align LG stacking kit to the
appliance
Type A
550 mm the
1
*1
depth 599 mm
1
• For Type A, it must be assembled with
550R or 550L on upper part.
• For Type B, it must be assembled with
600R or 600L on upper part.
*1 The depth of the washing machine
1
Place the appliance on the top of an
LG front load washing machine.
2
Remove the 2 screws from the
bottom of the rear cover on each
side.
3
Align the LG stacking kit holes and the
rear cover holes in a line.
Type B
600 mm the
1
*1
depth 650 mm
1
• In case of that the depth of the
washing machine is 550 mm or
more and 599 mm or less
• In case of that the depth of the
washing machine is 600 mm or
more and 650 mm or less
4
Fasten the 2 screws that were
removed earlier from the appliance
to the stacking kit.
5
Use the 4 screws in the accessory box
(16 mm) to assemble the washing
machine rear cover and stacking kit.
6
The procedure for the opposite side
will be the same.
Installing the Optional Drain
Hose
Normally, condensed water is pumped
up to the water container where water is
collected until manually emptied. Water
can also be drained out directly to a
mains drain, especially when the
appliance is stacked on top of a washing
machine. With the connecting elbow or T
piece of the mains drain hose, simply
change the water path and re-route to
the drainage facility as below: