Table of Contents
Advertisement
en Troubleshooting
Fault
The drying time is too
long.
"Please clean lint fil-
ter " and the appli-
ance is not respond-
ing to operation.
"Selfcleaning"
Water is leaking from
the appliance.
"Refresher-container
is empty, please re-fill.
"
58
Cause and troubleshooting
Remote start is activated and the ambient temperature
is lower than 16 °C.
Ensure that the ambient temperature is above 16
▶
°C or start the next drying process within 2 hours.
→ " Technical data", Page 63
The ambient temperature is low and the base unit fil-
ter is damp.
→ "Cleaning the filter system on the base unit",
1.
Page 36.
Dry the filter thoroughly after cleaning.
2.
→ "Closing the base unit", Page 51.
3.
→ "Switching off the appliance", Page 36.
4.
→ "Switching on the appliance", Page 35.
5.
→ "Starting the programme", Page 36.
6.
Automatic self-cleaning function rinses the appliance's
heat exchanger.
Not a fault.
1.
Do not pull out the condensation tank.
2.
Do not cancel the programme.
3.
Appliance is not correctly aligned.
→ "Aligning the appliance", Page 16
▶
The seal for the heat exchanger cover is dirty.
Clean the seal for the heat exchanger cover.
▶
→ "Cleaning the filter system on the base unit",
Page 36
Water drain hose is not connected correctly.
Ensure that the water drain hose is connected cor-
▶
rectly.
→ "Connecting the water drain hose", Page 14
The lever for the heat exchanger cover is not closed
correctly.
Ensure that the lever for the heat exchanger cover
▶
is closed correctly.
→ "Closing the base unit", Page 51
The water tank for the crease-removal function is
empty.
Fill water tank.
▶
→ "Filling the water tank", Page 40.
Advertisement
Table of Contents
