Table of Contents
Advertisement
PRODUCT ASSEMBLY
3
Place the Bowl* on the Clamping Plate
and twist to lock in place.
5
Unlock the Motor Head and move it
down. Then, lock** the head to keep
it down. Before mixing, test lock by
attempting to raise the Motor Head.
(OPTIONAL) To adjust Beater to Bowl*
Clearance: Tilt and lock** the Motor
Head back. Turn the screw slightly
counterclockwise (left) to raise the
beater, or clockwise (right) to lower it.
NOTE: If you over-adjust the screw,
the Bowl* Lock Lever may not lock into
place.
*The Bowl design and material depend on the Stand Mixer model.
**Locking option is available on select models.
***Included with select models only. Also available as an optional accessory.
6
W11674488A.indb 6
W11674488A.indb 6
4
Slide and rotate the accessory, aligning
over the pin on the shaft.
(OPTIONAL) Place the Pouring
Shield***: From the front of the Stand
Mixer, place the Pouring Shield***
onto the Bowl* so that the Motor Head
covers the u-shaped gap in the shield.
This will position the Pouring Chute just
to the right of the Attachment Hub as
you face the mixer. Press lightly so that
the Easy Snap tabs snap the shield onto
the Bowl*.
1
2
6/9/2023 2:50:41 PM
6/9/2023 2:50:41 PM
Advertisement
Table of Contents
