Craftsman 973.111330 Owner's Manual page 8

SWITCH
See Figure 2.
To turn your drill ON, depress the switch trigger. To
turn it OFF, release the switch trigger.
CENTER POSITION
(LOCK)
VARIABLE SPEED
This tool has a variable speed switch that delivers
higher speed and torque with increased trigger
pressure. Speed is controlled by the amount of switch
trigger depression.
Note: You might hear a whistling or ringing noise from
the switch during use. Do not be concerned, this is a
normal part of the switch function.
TO INSTALL BATTERY PACK
Lock switch trigger on your drill by placing the
direction of rotation selector in center position.
See Figure 2.
Place battery pack in your drill. Align raised rib
inside drill with groove on battery pack.
Figure 3.
OPERATION
SELECTOR
SWITCH
TRIGGER
Fig. 2
See
BATTERY
PACK
DEPRESS LATCHES
TO RELEASE
BATTERY PACK
Make sure the latches on each side of your
battery pack snap in place and battery pack is
secured in drill before beginning operation.
CAUTION:
When placing battery pack in your
drill, be sure raised rib inside drill aligns with
groove on battery pack and latches snap in place
properly. Improper assembly of battery pack can
cause damage to internal components.
TO REMOVE BATTERY PACK
Lock switch trigger on your drill by placing the
direction of rotation selector in center position.
See Figure 2.
Locate latches on end of battery pack and
depress to release battery pack from your drill.
See Figure 3.
Remove battery pack from your drill.
8
LATCHES
Fig. 3