GE ZTDX1DSSN Installation Instructions Manual page 6

10
INSTALL MOUNTING SCREWS (THERMAL OVENS)
WARNING
Mounting screws must be
used. Failure to do so could result in the oven
falling out of the cabinet, causing serious injury.
NOTE: During oven mounting step, ensure that
no damage is done to oven gasket which lines
the edge of oven cavity.
NOTE: Before drilling the pilot holes, make
sure the oven is pushed as far back into the
opening as it will go and is centered.
NOTE: If the cabinet is particle board, you
must use #8 x ¾" particle board screws. These
may be purchased at any hardware store.
A. Drill through the mounting holes (top and
bottom) of the side trim for the #8 mounting
screws provided.
B. Secure the oven cabinet with the screws
provided.
Some models have custom handles. Please follow the instructions with the handles for
proper installation.
11
BOTTOM TRIM INSTALLATION
With oven installed, attach the bottom trim through its mounting holes in front vertical brace using
two trim screws provided. Bottom trim lip must be placed under flange of bottom air duct.
Single, Combination, and Double Wall
Oven Installations without a Pedestal
IMPORTANT: If this unit is ever removed from the cabinet or the oven is ever pulled out for
service, the bottom trim must be removed first or damage to the trim will occur.
The Screws
Mounting
Must Be a
Hole
Minimum of
Locations
1/4" (6 mm)
(hole locations
From the
may vary)
Front of
the Cutout.
Double Wall Oven Installations
with a Pedestal
12
OVEN RACK GUIDE INSTALLATION (IF APPLICABLE)
A. Locate included oven rack guide mouting hardware.
B. Place oven rack guides on cavity wall studs with metal posts towards back of cavity as shown.
C. Install guides using the 8 provided mounting nuts.
Metal Posts to be installed
in the rear of cavity
Oven rack guide
shown in place.