Individual Operations - Pioneer SP-X707 Operating Instructions Manual

OPERATION
Condition: When control unit selector on rear panel of SP-X707 is set to B,
PRESS the FUNCTION key.
weet B
+ 2
ve vin kw UR eae ot ne.
Fi wait
ti
a a a a
OooogOoOOooO sx
This combination
. Cannot be used.
Surround Volume
Balanc
(Press both sides to
center balance.)
Next adjust the master arnplifier.
Press the AMP key
to bring up this display:
* Loudness ON/OFF © Stereo Mode (Stereo -L--R)
VGN cee A AUN OO"
Ce
ib wef 2 nem 1ran now Ausie |
| tt
'ON/OFF TRAC Tt
oe
| Ae
=
* Front Volume Balance
Sound Mode ¢——> ae
oonn OOOO
ss et
: ' Bo
{Press both sides to Selection
center balance.) 1; WIDE 2: SS. WIDE OFF: Sound effect off
14
<ARE1016>
INDIVIDUAL OPERATIONS
= COMBINING THE SURROUND SYSTEM WITH RECORD PLAYBACK
Here we have used the case of turntable playback as an example, but if another function (audio
source) is selected on the amplifier side, the above function can also be used for such other
sources.
— Perform the following operations in numerical order. —
A," :
Front speaker
"La | }
Select the amplifier
PHONO function.
Turn ON the MAIN POWER
switch. Turn ON the SYSTEM
POWER switch.
in the case of equipment other
than the Pioneer Audio-Video
master amplifier, turn ON the
tape monitor (adaptor) switch,
in accordance with the ter-
minal used for connection to
the SP-X707.
AUDIO/ADAPTOR
Play a record on
the turntable.
Always make sure to turn
the TAPE MONITOR
switch OFF,
Always make sure to turn
MUTING OFF.
volume can be adjusted t panel in the same way.
3
>
STONE
Surround speaker
SP-X707
Turn ON the POWER switch.
The STAND-BY indicator will turn off and the
Power indicator and the unit will turn ON.
Power indicator
STAND-BY
indicator Turn ON the POWER switch.
The STAND-BY indicator will turn orange
and the unit will go into stand-by mode.
15
<ARE1016>