Kenwood KR-7600 Instruction Manual page 7

CONNECTING INSTRUCTIONS
TAPE DECK CONNECTION
Recording
A tape deck can be connected for recording as follows: left
channel input of the tape deck to TAPE A (or B) REC "'L" jack, right
channel input of the tape deck to TAPE A (or B) REC "R"' jack.
Playback
A tape deck can be connected for playback as follows: left
channel output of the tape deck to TAPE A (or B) PLAY "L" jack, right
channel output of the tape deck to TAPE A (or B) PLAY 'R" jack.
DIN CONNECTOR (PLAY/REC CONNECTOR)
If your tape deck is equipped with a DIN connector, connect it to
"TAPE A" PLAY/REC connector with a DIN connecting cord. A DIN
connector enables recording and playback with this single cord.
NOTE: When a DIN cord is connected, TAPE A PLAY and REC jacks should not be
used. However, TAPE 8 PLAY and REC jacks can always be used
regardless of the DIN cord connection.
AUX (AUXILIARY INPUTS)
High level INPUT AUX jacks are for miscellaneous sources, such
as extra tape decks, additional tuners, TV sound outputs, and other ex-
ternal components.
AC OUTLETS
The AC outlets on the rear panel of the receiver may be used to
supply power to other components, such as a turntable. tape deck, etc.
1. SWITCHED outlet
This outlet ts controlled by the POWER switch on the front panel.
{The capacity is 100 watts maximum).
2. UNSWITCHED outlets
These outlets deliver power at all times. (The total capacity is
200 watts maximum.)
NOTE: 1. Donot connect here any equipment whose power consumption exceeds
the capacity of each outlet.
2. Units shipped to the European countries are not equipped with the AC
Outlets.
FM DEF OUT JACK
The FM detector circuit output is made available here so that thrs
receiver will be ready for 4-channel broadcasting developments in the
future. When FM discrete 4-channel broadcasting becomes 4a reality.
a simple der..odulator connected here will enable you to fully enjoy this
coming development.
ADAPTOR IN-OUT JACKS
When ji is desired to set up a 4-channel stereo system or a Dolby
NR system, remove the attached jumper connector and connect
another decoder amplifier or Dolby NR adaptor to the ADAPTOR
jacks. For cstailed instructions on connections, etc., see the instruc-
tion manual supplied with the adaptor.
NOTE: Wher using the ADAPTOR jacks do not use the attached jumper connector
in other jacks. Keep it, because it must be plugged into these jacks when
they are not used.
KR-7600(K} 7