Kenwood KR-7600 Instruction Manual page 12

OPERATING INSTRUCTIONS
HOW TO USE THE ADAPTOR JACKS (1)
e Dolbyized FM Broadcasts Reception
1. Remove the attached jumper connectors and connect the Dolby
NR adaptor to the ADAPTOR jacks as shown in the figure below
(A).
2. Set the INPUT SELECTOR switch to FM and tune in to a
Dolbyized FM Broadcast.
3. Set the FM 25us switch on the front panei to the depressed
position.
NOTE; When using the ADAPTOR jacks do not use the attached jumper connector
for other jacks. Keep it, because it must be plugged back into these jacks
when they are not used.
e@ Dolby System Recording and Playback
Recording
Connect the Dolby NR adaptor output jacks to the tape deck
LINE-INPUT jacks.
2. Select the program source of your choice with the INPUT
SELECTOR switch.
iP
(B)
12
KR-7600 (K)
TONE TNE LT
ADAPTOR OT ADAPTOR 1N ALAR TOR oul
FRA 25 eS
Fil SWITCH tM
— a ap ey . —- . a de meters
DOLBYIZED INPUT ON AY OFF SIGNAL HOP Bb yil/7b b INPUT
FM STEREO SELECTOR 4 PM STERES® SELECTOR
BROANCAS I SWIitlGH BROARCAS! SWITCH
Rt Bee
ARAPTO
PMI 25 9:
SWITCH
INS
%
3. Set the FM 25us switch to the protruded position. (Set the FM
25us switch to the depressed position when recording Dolbyized
FM broadcast.)
Playback :
2. Playback your Dolbyized recording. See figure below (B).
FRONT
SPEAKER
LIME OED TAL
ji
ADAP Tony
CT
ADAP LOR IN
IN
REAR
SPEAKER
J
It SIN Al
4CH DECODER AMP