Advertisement
IDE HDD Block Mode
Block mode is also called block transfer, multiple commands, or
multiple sector read/write. If your IDE hard drive supports block mode (most
new drives do), select Enabled for automatic detection of the optimal number
of block read/writes per sector the drive can support. The settings are:
Enabled, Disabled.
Onboard FDC Controller
Select Enabled if your system has a floppy disk controller (FDD)
installed on the system board and you wish to use it. If you install add-on
FDC or the system has no floppy drive, select Disabled in this field.
The settings are: Enabled and Disabled.
Onboard Serial Port 1/Port 2
Select an address and corresponding interrupt for the first and
second serial ports. The settings are: 3F8/IRQ4, 2E8/IRQ3, 3E8/IRQ4, 2F8/
IRQ3, Disabled, Auto.
Onboard IR Controller
This item allows you to Enabled or Disabled the onboard IR(Infrared)
controller.
IR Address Select
This item allows you to select which address the IR will occupy.
IR Mode
This item allows you to select the IR mode.
IR Transmittion Delay
This item allows you to Enabled or Disabled the IR transmitting delay.
IR IRQ Select
This item allows you to select which IRQ the IR will occupy.
IR Mode Use DMA
This item allows you to Enabled or Disabled the IR using DMA
mode.
3-17
®
Advertisement
