U-Line UMCR014-D01A User Manual & Service Manual page 46

USER GUIDE
REPLACING ICE MAKER ASSEMBLY (ALL MODELS
EXCEPT CO29F)
1. Remove back panel.
2. Disconnect all wires at bell connectors (5 wires-Models
BI95, BI98 or SP18; or Plug-Models).
3. Remove capillary tube from sensing tube on ice maker
assembly (2).
4. Remove water inlet tube.
5. Remove front cover (3)
6. Advance ejector blades to the 3:00 position by turning the
5/16" hex head on the small brass gear counterclockwise
(4).
7. Remove two screws from the side wall of evaporator (5).
8. Remove screws from the bottom of the evaporator plate.
9. Remove ice maker assembly from evaporator shelf.
10. Clean alumilastic from evaporator shelf.
11. Apply 1/4" layer of fresh alumilastic to heater side of new
ice maker.
12. Replace parts in reverse order of removal.
13. Reconnect all wires.
14. Insert capillary tube into ice maker sensing tube.
15. Insert water inlet tube.
16. Apply permagum to all exit holes. Mount back panel.
Troubleshooting Extended
17.Mount the back panel.
18.Plug in unit and test.
220 Volt Conversion List
All models listed in this manual are equipped to run on
110/115 volt. This document is a conversion list for the
applicable 220 volt parts for the following models:
• SP18
• BI95
• BI98
• SS1095
110V P/N 220V P/N
5263-S 5195
80-39015-00 628109
402 619
402-29/1175 620
2552A 2555A
5402-S 5404-S
150 650
5414 5418
5413 5417
46
Description
Fan Motor
I.M. motor (ice makers)
Ice maker assembly -
Models SP18, BI95, BI98
and model SS1095
Ice maker assembly -
Models SP18, BI95, BI98
and model SS1095
Water valve
Compressor (ice makers)
Faceplate assembly
Relay
Overload