Trouble Shooting; Rectifying Faults Yourself; Maximum Operating Time - Bosch HBA574B 0 Series Instruction Manual

Trouble shooting

en
3Trouble shooting
I f a fault occurs, there is often a simple explanation.
T r o u b l e s h o o t i n g
Before calling the after-sales service, please refer to the
fault table and attempt to correct the fault yourself.

Rectifying faults yourself

You can often easily rectify technical faults with the
appliance yourself.
If a dish does not turn out exactly as you wanted, you
can find useful cooking tips and instructions at the end
of this instruction manual. ~ "Tested for you in our
cooking studio" on page 28
Fault Possible
cause
The appliance is Defective cir-
not working. cuit breaker.
Power failure Check whether the kitchen light
The time is flash- Power failure. Reset the time.
ing on the display.
The settings on The child-
the appliance proof lock is
cannot be config- activated.
ured. A key sym-
bol has lit up on
the display or
†'"".
The appliance The appliance
door will not door is locked
open. A key sym- with the child-
bol has lit up on proof lock.
the display.
The appliance The appliance
door will not door is locked
open. A lock by the clean-
symbol H has lit ing function.
up on the display.
After an operating The appliance
mode is switched has not
on, œ is flashing cooled down
on the display. sufficiently.
The appliance is Demo mode
not heating. The is activated.
colon is flashing
on the display. On
some appliances,
a š will also
appear on the dis-
play.
--------
24
Notes/remedy
Check the circuit breaker in the
fuse box.
or other kitchen appliances are
working.
Deactivate the childproof lock by
pressing and holding the button
with the key symbol for approx. 4
seconds.
Deactivate the childproof lock by
pressing and holding the button
with the key symbol for approx. 4
seconds.
The lock can be switched off in
the basic settings.
Wait until the cooking compart-
ment has cooled down and the
lock symbol H has gone out.
Switch off the appliance, allow it
to cool down and switch on the
operating mode again.
Briefly disconnect the appliance
from the mains (switch off the cir-
cuit breaker in the fuse box) and
then deactivate demo mode
within approx. 5 minutes by
changing the basic setting ™‚„
or ™› to ‹. ~ "Basic settings"
on page 16
:
Warning – Risk of injury!
Incorrect repairs are dangerous. Do not attempt to
repair the appliance yourself. Repairs must only be
carried out by one of our trained after-sales engineers. If
the appliance is defective, call the after-sales service.
:
Warning – Risk of electric shock!
Incorrect repairs are dangerous. Repairs may only be
carried out and damaged power cables replaced by
one of our trained after-sales technicians. If the
appliance is defective, unplug the appliance from the
mains or switch off the circuit breaker in the fuse box.
Contact the after-sales service.
Error messages on the display
If an error message with """ appears on the display,
e.g. "‹†-„ƒ, touch the v button. This will reset the
error message. Reset the time, if necessary.
If the fault was a one-off, you can continue to use your
appliance as normal. If the error message appears
again, call our after-sales service and quote the exact
error message and the E no. of your appliance.
~ "Customer service" on page 25

Maximum operating time

If you do not change the settings on your appliance for
several hours, the appliance will stop heating
automatically. This prevents unintentional continuous
operation.
When the maximum operating time is reached depends
on the various different settings that have been
configured on the appliance.
Maximum operating time reached
"‰ appears on the display.
Turn the function selector to the "Off" position. You can
configure new settings if required.
To prevent the appliance from switching off when
Tip:
you do not want it to, e.g. with an extremely long
cooking time, you should always set a cooking time.
The appliance will heat up until the set cooking time has
elapsed.