Remote Control Battery Installation - Panasonic TC-15LT1 Operating Instructions Manual

Installation
Remote control battery installation
Remove the insulation sheet. Back of the Remote Control
The lithium battery is included in the remote control
at the time of delivery.
Remove the insulation sheet to operate the
remove control.
the insulation sheet
Replacing batteries
Replace batteries by following the steps below:
"Replacing batteries" label
Requires a 0R2025 battery
1. Draw out the battery tray by sliding 2. Remove battery as shown below.
latch [] and pulling in the direction Install the battery in the battery
of [] as shown below, tray. (Confirm that the positive
pole marked" +" is facing up.)
3. Replace the tray and slide back
the latch until it snaps in place.
/_k Caution
Keep batteries out of children's reach. If batteries are swallowed, contact a physician immediately,
Z_
Precaution on
battery
use
Incorrect installation can cause battery leakage and corrosion that will damage the remote control transmitter.
Observe the following precautions:
1. Always use new batteries when replacing the old set.
2. Do not attempt to charge, short-circuit, disassemble, heat or burn used batteries.
3. Battery replacement is necessary when remote control acts sporadically or stops operating this unit.
Notes:
• Do not drop, apply shock or step on the remote control.
• Do not spill water on the remote control.
• Do not place objects between the remote control and remote control receiver.
• Do not use remote controls for other equipments at the same time.
• If the TV does not operate even when operating the remote control from a close range, it is time to replace the
batteries (product number: CR2025).
Refer to the label on back of the remote control for directions on replacing batteries.
AC Adaptor installation
• Be sure to use the power cord and AC adaptor (model no. : NOJZHK000003) included in the accessories.
• Usage of AC adapters other than specified may cause malfunctions.
7