Table of Contents
Advertisement
Fault
Error code ":Ġ is lit.
Error code ":ƒˆ is lit.
A different error code is
indicated on the digital
display.
(":‹‚ to ":„‹)
Display flashes
Refill indicator for salt h
and/or rinse-aid ` is lit.
Refill indicator for salt h
and/or rinse-aid `
is not lit.
Water is left
in the appliance at the end
of the programme.
Cause
Waste water pump blocked
or cover on the waste water
pump is not locked in position.
Mains voltage too low.
A technical fault has probably
occurred.
Door not closed properly.
Pause function activated. *
No rinse aid.
No salt.
Sensor does not detect salt
tablets.
Refill indicator switched off.
There is still enough special salt/
rinse aid available.
Filter system or area under
the filters 1R is blocked.
The programme has not yet
ended.
Fault, what to do?
Remedial action
Clean pump and lock cover correctly. (See
Waste water pump)
Not an appliance fault, have the mains
voltage and electrical installation checked.
Switch off appliances with the ON/OFF
switch (. After a short time restart
the appliance.
If the problem recurs, turn off the tap and
pull out the mains plug.
Call customer service and mention the error
code.
Close the door. Ensure that no objects
(utensil, fragrance dispenser) are protruding
over the basket and preventing the door
from closing.
Press the Start button again to continue the
rinse programme. *
Refill rinse aid.
Refill with special salt.
Use different special salt.
Activation/deactivation (see chapter Water
softening system/Special salt or Rinse aid).
Check refill indicator, levels.
Clean filters and area underneath (see
Waste water pump).
Wait until programme ends or reset (see
Terminating the programme).
en
29
Advertisement
Table of Contents
