Selecting A Location - Miller Deltaweld 652 Owner's Manual

4-4. Selecting A Location

Movement
Location And Airflow
3
4
1
OR
18 in
(460 mm)
Return To Table Of Contents
1 Lifting Eye
2 Lifting Forks
Use lifting eye or lifting forks to
move unit.
If using lifting forks, extend forks
beyond opposite side of unit.
3 Rating Label (Non CE Models
Only)
Use rating label to determine input
power needs. Label located under
front access door.
2
4 Plate Label (CE Models Only)
Label located under front access
door.
5 Rating Label (CE Models
6
Only)
Use rating label to determine input
power needs. Label located on rear
access door (see Section 3-5).
6 Line Disconnect Device
Locate unit near correct input pow-
er supply.
18 in
(460 mm)
Y Special installation may be
required where gasoline or
volatile liquids are present −
see NEC Article 511 or CEC
Section 20.
5
Ref. ST-800 453-A
OM-223 Page 15