Table of Contents
Advertisement
REMOVING THE SPEAKERS
@
Push the speaker assembly/removal tab on the rear of the main unit in the direction of the arrow.
@
Slide the speaker enclosure upward to remove it.
POWER
REQUIREMENTS
[D] TO USE WITH
BATTERIES
Set the AC/BATT.
(DC) selector to "BATT"
and insert 8 IEC R20 batteries.
Note: The volume drops and the tape speed gets slower as the batteries are exhausted; replace the batteries
when this happens.
[E] TO USE WITH HOUSEHOLD AC
Set the AC/BATT.
(DC) selector to ''AC'' and insert the AC power (mains) lead plug to the AC outlet.
Note:
When the AC/BATT.
(DC) selector is not set to "AC" with the batteries left in the compartment, the
batteries will be discharged.
—F
* Set the VOLTAGE seletor to your local power (mains) voltage before using this unit.
¢ Connect the AC power (mains) lead plug to the provided plug adaptor and then insert it into the
household AC socket when using the unit in a 200—220V and 230—250V area.
Note:
Set the VOLTAGE selector to your local voltage with the power (mains) lead unplugged.
Replacement plug: Replacement plugs are packed in the provided
plug adaptor; install the plug fit to your wall socket as shown in the
figure to use the adaptor.
Note: Tighten the replacement plug firmly by the screw.
Do not just insert it into the socket; it is dangerous.
=
[F] TO USE FROM A CAR BATTERY
|G| TO LISTEN TO A RADIO PROGRAMME
© (s
Set the FM MODE selector to "STEREO" when the station is broadcasting an FM stereo progranme.
¢ When an FM stereo signal is weak or noisy for enjoyable stereo listening, set the FM MODE seector
to "MONO"
to reduce the noise.
ANTENNA
(AERIAL) INFORMATION
SW2 reception:
Extend the telescopic antenna (aerial) to its full length.
Advertisement
Table of Contents
