Channel Management; Digital Reception Test; Factory Settings - Philips 42PFL9703D User Manual

6.4

Channel management

6.4.1 Automatic search
Once a day, at 3 AM, the TV searches for all
available TV channels automatically. Leave your TV in
standby.
Earlier found channels are updated and new
channels are stored. Channels not found by the
search anymore are removed from the channel list.
When Channel management has found or removed
channels, a message at TV start up is shown. You
can activate or deactivate this message.
‡ Press Menu and select Setup > Installation >
Channel installation > Startup message.
® Select On or Off.
6.4.2 Manual search
You can install the updates at any time.
‡ Press Menu and select Setup > Installation >
Channel installation > Installation update.
® Press π to enter the Installation update menu.
Ò Press
.
OK
† Press the green key to start.
The update starts and may take a few minutes.
º When the update is completed, press the red
key to return to the Channel installation menu.
◊Press Menu to quit the menu.
28
6.5

Digital reception test

If you receive Digital TV broadcasting you can verify
the quality and signal strength of a specific channel.
‡ Select a channel.
® Press Menu and select Setup > Installation >
Channel installation > Digital:Test reception.
Ò Press π to enter
† Press
OK .
º Press the green key to start the test.
Information on the quality and the signal
strength of this channel is shown.
◊Use the cursor keys to change the frequency to
improve the signal or enter a new frequency
directly with the digit keys.
‹ Press the green key to store the frequency if
the signal quality and strength are good.
≈Press the red key to return to the Channel
installation menu.
Ú Press Menu to quit the menu.
à Tip
To achieve the best results, contact a specialised
antenna installer.
6.6

Factory settings

You might want to return to the original factory
settings. Only picture and sound settings will be
reset.
‡ Press Menu and select Setup > Installation >
Factory settings.
® Press π to enter the Factory settings menu.
Ò Press
.
OK
† Press Menu to quit the menu.
Channel installation