Preparation; Unpacking The Tv - JVC LT-32C785B Instruction Manual

32" led smart hd tv with built-in dvd player

Hide thumbs Also See for LT-32C785B:

Quick start manual (2 pages)

Table Of Contents

Table of Contents

Chapter

Preparation

Thank you

Your new TV has many features and incorporates the latest technology to enhance your viewing

experience. We recommend that you spend some time reading this instruction manual so that you fully

understand these features. You will also find some hints and tips to help you resolve any issues.

Read all the safety instructions carefully before use and keep this instruction manual for future reference.

Unpacking the TV

Remove all packaging from the TV. Retain the packaging. If you dispose of it please do so according to local regulations.

The following items are included:

TV Stand (base)

Instruction Manual

32" LED Smart HD TV

with built-in DVD player

LT-32C785(B)

Instruction Manual

JVC 32' LED Smart HD TV with built-in DVD player LT-32C785(B) Manual.indd 8

for purchasing your new JVC TV.

Quick Start Guide

32" LED Smart TV

with built-in DVD player

LT-32C785(B)

JVC 32' LED Smart HD TV with built-in DVD player LT-32C785(B) Quick Start.indd 1-3

Quick Start Guide

Stand screws x6

TV Stand (neck)

Thank you

for purchasing your new JVC TV.

Connecting the Aerial and Turning on the TV

The latest eco-friendly power-saving technology will switch off the TV if

Your new TV incorporates the latest technology to enhance your viewing

experience. We would suggest that you allow about 15 mins for initial setup.

it is left on and idle for 4 hours. Please refer to "Auto Standby" under the

"Time Settings" section of the instruction manual for more detail.

Please follow this guide for a successful first time installation.

1. Connect one end of the RF coaxial cable to the aerial socket on the wall and the other end of the cable to the ANT socket on the back of your TV.

Setup in

2. Plug the TV into a mains socket and switch on at the mains.

What's in the Box?

3. In standby mode, press the

15mins

Remove all packaging from the unit. Retain the packaging. If you dispose of it please do so according to any local regulations.

Remote Control/

Instruction Manual

Please inspect your TV for damage after unpacking. If

TV Stand Base

AAA Batteries x2

Quick Start Guide

you do notice any damage please consult your dealer.

Stand Screws x 6

TV Stand Neck

Operating Your Remote Control

1. Slide open the battery compartment on the back of the remote control.

2. Insert two AAA size batteries. Make sure to match the (+) and ( - ) ends of

the batteries with the (+) and ( - ) ends indicated in the battery compartment.

3. Slide the battery compartment cover back into place. Make sure it clicks into place.

Installing the Base Stand

Fitting the Stand Neck and Base Together

1. Fit the neck onto the base.

2. Using 2 of the supplied screws, screw the neck to the base.

Fitting the Stand Neck and Base Together

1. Ensure the TV is switched off and not connected to the mains power supply.

2. Lay the TV down on a flat surface ideally on the edge of a table so the base of the TV slightly

overhangs the edge of the table, with the back side facing up. Please make sure a soft cushioned

material (such as a dry bath towel or thick piece of foam) is placed beneath the screen.

3. Slide the stand under the lip, the neck will fit snugly over the screw holes. Then screw the stand

to the TV using the 4 screws supplied.

Protective

Bag

Router

(not included)

LAN

SPDIF

VGA

Optic.OUT

SCART

Slide under

the lip

Cushioned

Table

material

• Do not connect the TV to the mains supply until you have completed all the connections.

• Always disconnect the TV from the mains socket when not in use for a long period of time.

The LCD display is very fragile, and must be protected at all times when installing and removing the base stand. Be sure that no hard or sharp object, or

• The

button on the remote control is only used for switching the TV into standby, it does not disconnect the TV from the mains power.

anything that could scratch or damage the LCD display, comes into contact with it. DO NOT exert pressure on the front of the TV at any time because the

screen could crack.

To completely disconnect the mains power, please remove the mains plug from the mains socket.

.,/@

ABC

DEF

GHI

JKL

MNO

PQRS

TUV

WXYZ

EPG