Table of Contents
Advertisement
Available languages
Available languages
A drain and spin may help shorten drying times for some fabrics
by removing excess water. Set Options Control (if available) to
One Rinse. You should then set Cycle Selector (Timer) Control to
a Spin setting.
LJi _ i_i_i
_ dii @ ii:_!_,
ii]ii:iii _11i
,_i:i::I
ii ! ii,_
_!!ili!i W_ii!i!iii
_!i_ !i_i ,_i!i?
_l ¸¸_¸
Ob_f(:i;:
!i!i!i!
_iii!)_'!!ii;
When the Cycle Control knob is set to a number and pulled out,
the washer fills (to the selected load size) before agitation and
timing start. The washer begins agitating immediately after filling;
agitation occurs with the washer lid down.
During agitation, the agitator creates a continuous rollover action
that provides a thorough cleaning of the wash load.
After agitation starts, the Cycle Control knob turns clockwise until
it points to an OFF area and the cycle ends.
NOTE: The washer pauses briefly throughout
each cycle. These
pauses are normal for washer operation.
WASH
RINSE
1.Fill
_
1.Fill
2. Wash selected
_
2. Rinse
time
3. Drain* No
I
I
3. Drain No
agitation
__
agitation
4. Spin
4. Spin-Spray
rinse
5. Spin
The Permanent Press cycle
I
r-_
I
6. Off
partially drains, fills, agitates
LJ
briefly, and drains.
! ©
;: ::::o
:::
Your new washer may make sounds your old one didn't. Because
the sounds might be unfamiliar, you may be concerned
about
them. These sounds are normal.
During washing
When you select a small load size setting, your washer has a
lower water level. This can cause a clicking sound from the upper
part of the agitator.
During drain
If water is drained quickly from your washer (depending on your
installation), you may hear air being pulled through the pump
during the end of draining.
After drain and before spin
When the cycle changes from draining to spinning, you may hear
gears engaging.
LAUNDRY TIPS
Preparing
clothes for washing
Follow these recommendations
to help you prolong the life of
your garments.
•
Close zippers, snaps, and hooks to avoid snagging other
items. Remove pins, buckles, and other hard objects to avoid
scratching the washer interior. Remove non-washable
trim
and ornaments.
•
Empty pockets and turn them inside-out.
•
Turn down cuffs; brush away lint and dirt.
•
Turn synthetic knits inside-out to avoid pilling.
•
Tie strings and sashes so they will not tangle.
•
Mend tears, loose hems, and seams.
•
Treat spots and stains.
•
Stained or wet garments should be washed promptly for best
results.
Sorting
•
Separate heavily soiled items from lightly soiled ones, even if
they would normally be washed together. Separate lint-givers
(towels, chenille) from lint-takers (corduroy, synthetics,
permanent press). When possible, turn lint-givers inside-out.
•
Separate dark colors from light colors, colorfast items from
noncolorfast
items.
•
Sort by fabric and construction
(sturdy cottons, knits, delicate
items).
Unloading
•
Remove clothes from washer after the cycle is completed.
Metal objects such as zippers, snaps, and buckles may rust if
left in the washer basket for a long time.
15
Advertisement
Chapters
Table of Contents
