Dell OptiPlex Small Form Factor 7010 Owner's Manual page 84

Steps
1. Remove the protection mylars from the internal antennas.
2. Insert the antennas into the slots on the chassis.
The antennas should be installed on the appropriate slots on the chassis. The following table provides guidance on the
correct installation method.
CHASSIS LABEL
ANT-W
ANT-B
3. Replace the two screws (M3x3) that secures the internal antennas to the chassis.
4. Route the internal-antenna cable through the routing guides on the chassis.
Next steps
1. Install the wireless card
2. Install the disk-drive cage.
3. Install the 3.5-inch hard drive
4. Install the 2.5-inch hard drive
84 Retrait et installation des unités remplaçables sur site (FRU)
if applicable.
if applicable.
if applicable.
ANTENNA-CABLE COLOR
White
Black