Table of Contents
Advertisement
Important
Safety Instructions
17) If an outside
antenna
is connected
to the
television equipment, be sure the antenna system
is grounded
so as to provide some protection
against
voltage
surges
and built up static
charges.
In the U.S. Selection
810-21 of the
National Electrical
Code provides information
with respect to proper grounding of the mast and
supporting structure, grounding of the lead-in wire
to an antenna discharge unit, size of grounding
conductors,
location of antenna discharge unit,
connection
to grounding
electrodes,
and
requirements for the grounding electrode.
18) An outside antenna system should not be located
in the vicinity of overhead power lines or other
EXAMPLE OF ANTENNA
GROUNDING AS PER(NEC)
NATIONAL ELECTRICAL _
_..
CODE
4._
ANTENNA
LEAD-IN WIRE
R°uND '
CLAMP
I
LRAOMUp_
_
ANTENNA
/.q°,.c..
(NEC SECTION
810-20)
GROUNDINGCONDUCTORS
L_E
NT_
_
(NECSECTION810-21)
GROUND CLAMPS
_OWER
SERVICE GROUNDING
ELECTRODE SYSTEM
(NEC ART 250, PART H)
electric light or power circuits, or where it can fall into such power lines or circuits. When installing an
outside antenna system extreme care should be taken to keep from touching such power lines or circuits
as contact with them might be fatal.
19) Unplug this LCD TV from the wall outlet, and refer servicing to qualified service personnel
under the
following conditions:
a. When the power cord or plug is damaged or frayed.
b. If liquid has been spilled into the LCD TV.
c. If the LCD TV has been exposed to rain or water.
d. If the LCD TV does not operate normally by following the operating instructions.
Adjust only those controls that are covered by the operating instructions as improper adjustment of other
controls may result in damage and will often require extensive work by a qualified technician to restore
the LCD TV to normal operation.
e. If the LCD TV has been dropped or the cabinet has been damaged.
f. When the LCD TV exhibits a distinct change in performance - this indicates a need for service.
20) When replacement parts are required, be sure the service technician to use replacement parts specified by
the manufacturer that have the same characteristics
as the original part. Unauthorized
substitutions
may
result in fire, electric shock, or other hazards.
21)WARNING:
TO REDUCE
THE RISK OF FIRE OR ELECTRIC
SHOCK,
DO NOT EXPOSE
THIS
APPARATUS TO RAIN OR MOISTURE.
22) CAUTION:
TO PREVENT ELECTRIC
SHOCK DO NOT USE THIS PLUG WITH A RECEPTACLE
OR
OTHER OUTLET UNLESS THE BLADES CAN BE FULLY INSERTED TO PREVENT BLADE EXPOSURE.
23) CAUTION:
USE WITH OTHER STAND MAY RESULT IN INSTABILITY CAUSING POSSIBLE INJURY,
24) CAUTION:
DANGER OF EXPLOSION
IF BATTERY IS INCORRECTLY
REPLACED,
REPLACE ONLY
WITH THE SAME OR EQUIVALENT TYPE.
• Important Information Regarding Use of Video Games, Computers, Captions or Other Fixed Image Displays.
The extended use of fixed image program material can cause a permanent "shadow image" on the LCD panel.
This background image is viewable on normal programs in the form of a stationary fixed image. This type of
irreversible LCD panel deterioration can be limited by observing the following steps:
A,
Reduce the brightness/contrast
setting to a minimum viewing level,
B,
Do not display the fixed image for extended periods of time.
C, Turn the power off when not in actual use,
• This product utilizestin.lead solder,and has a fluorescent lamp containinga small amount of mercury. Disposal of
these materials may be regulated in yourcommunity dueto environmentalconsiderations.For disposalor recycling
information please contact your local authorities, or the Electronics IndustriesAlliance:
3
Advertisement
Table of Contents
