Table of Contents
Advertisement
en Water softening system
Place the lid back on the dis-
4.
penser and turn to close.
10.4 Switching off the water
softening system
If you find the special salt refill indic-
ator irritating, e.g. when using com-
bined detergents with salt replace-
ment substances, you can switch the
indicator off.
Note
To avoid damage to the appliance,
only switch off the water softening
system in the following cases:
The water hardness is max. 26 °E
¡
and you are using a combined de-
tergent with salt replacement sub-
stances. According to the manu-
facturers, combined detergents
with salt replacement substances
can generally only be used up to a
water hardness of 26 °E without
adding special salt.
The water hardness is 0 - 8 °E.
¡
You do not need to use special
salt.
Press
.
1.
To open the basic settings, press
2.
for 3 seconds.
The display shows H:xx.
a
The display shows
a
Press
repeatedly until the dis-
3.
play shows H:00.
To save the settings, press
4.
for 3 seconds.
The water softening system is
a
switched off and the salt refill indic-
ator is deactivated.
26
.
10.5 Regeneration of the wa-
ter softening system
In order to obtain fault-free function of
the water softening system, the appli-
ance performs regeneration of the
water softening system at regular in-
tervals.
Regeneration of the water softening
system takes place before the end of
the main rinse cycle in all pro-
grammes. It will increase the run time
and consumption values, e.g. water
and electricity.
Overview of consumption values
with regeneration the water
softening system
Here you can find an overview of the
maximum additional running time and
consumption values during regenera-
tion of the water softening system.
Regeneration of the water
softening system after x
washing programmes
Additional running time in
minutes
Additional water consump-
tion in litres
Additional power consump-
tion in kWh
The consumption values specified
are laboratory measurements determ-
ined in accordance with the currently
applicable standard using the Eco
50° programme and with the factory
value of the water hardness set to 16
- 20 °E.
6
6
5
0.05
Advertisement
Table of Contents
