Sony SA-W301 Operating Instructions Manual page 9

Using the PRE OUT Jacks (Without Jumper
Pins)
What cords will | need?
Audio connecting cord (supplied) (1)
White ro)
(L)
Red ©
(R)
Hookups
Connect the INPUT 1 jack of the woofer to PRE OUT
jacks (without jumper pins) of the amplifier with the
supplied audio connecting cord.
This woofer
INPUT 1
@ @
®®
=
Amplifier
PRE OUT
¢ What is a jumper pin?
Some amplifiers' PRE OUT jacks are equipped with the
jumper pins.
You cannot connect the woofer to such an amplifier.
Jumper pins
To connect to the amplifier's MONO OUT jack
Connect the woofer to the amplifier's MONO OUT jack in the
same way as you would connect the woofer to the PRE OUT
jack(s) using the supplied audio connecting cord. In this case,
use only one of the two (L or R) jacks. (Connect L to L or R to
R)
To connect to the amplifier's SUB WOOFER or SUPER
WOOFER output jack(s)
Connect the woofer to the amplifier's SUB WOOFER output
jack(s) or SUPER WOOFER output jack(s) in the same way as
you would connect the woofer to the PRE OUT jack(s) using
the supplied audio connecting cord.
| Getting Started
Notes
¢ If the output level of your amplifier is not large enough, the
sound may not be loud enough. In this case, connect the
speaker terminals of the amplifier directly to the INPUT2
terminals of the woofer.
¢ The SUB WOOFER output jack(s) or SUPER WOOFER
output jack(s) on an amplifier usually have built-in high-cut
(low-pass) filters. If the woofer is connected to such jacks,
the AUTO switch on the woofer may not function properly.
In this case, use the woofer with the AUTO switch turned off
(SA-W301 only). (See page 4.)
¢ If you are connecting the woofer to an amplifier equipped
only with a single jack (such as a MONO OUT jack, SUB
WCOEER output jack or SUPER WOOFER output jack etc),
connect one of the L (left) or the R (right) plugs of the
supplied audio connecting cord to such a jack and the other
Lor R plug to the corresponding jack (L or R) on the woofer.
In this case, make sure that you use only one of the two (L or
R) jacks on the woofer. Do not mix the plugs (L and R) as no
audio signal will be output.
Connecting the AC power cord
Connect the AC power cord from the woofer and from
your amplifier to a wall outlet.
Qf