Sony SA-W301 Operating Instructions Manual page 8

oo
. Getting Started
Using the Single Set of Speaker Terminals Using the Double (A+B) Sets of Speaker
Terminals
What cords will | need?
Speaker cord (supplied) (1 for each speaker) What cords will | need?
Speaker cord (supplied) (1 for each speaker)
—— >=
Twist the stripped ends of the cord about 2/3 inch (15 mm). Twist the stripped ends of the cord about 2/3 inch (15 mm).
Be sure to match the speaker cord to the appropriate terminal ;
on the componentes: + to + and — to -. If the cords are Hookups
reversed, the sound will be distorted and will lack bass. 1 Connect the amplifier and the speaker system.
It is useful to decide that the speaker cord marked with a line is Connect the speakers to your amplifier's speaker
== always the positive (+) and should be connected to the positive
terminals (A).
(+) terminal to avoid any improper connections. Amplifier
SPEAKER(A}
Hookups
1 Connect the amplifier. .
Connect the INPUT 2 terminals of the woofer to the
amplifier's speaker terminals with the speaker
cords. Be sure to connect both L and R channels.
See "Using the PRE OUT jacks" instead when you
use INPUT 1 jacks.
Amplifier
SPEAKER
PO OO
2 Connect the amplifier.
Connect the amplifier's speaker terminals (B) to the
INPUT 2 terminals of the woofer using speaker
cords (supplied). See "Using the PRE OUT jacks"
instead when you use INPUT 1 jacks.
This woofer
Amplifier
SPEAKER(8)
C0 00
2 Connect the speaker system.
Connect the speakers to the speaker terminals of the
woofer.
This woofer
SPEAKER
me
In
in)
ll
+
When using the double (A +B) sets of speakers, make
Speaker (L) sure that you select the "A +B" position with your
amplifier.
Speaker (R)
Note
When you are using speaker terminal (A) only (front speaker
only) or when the power of the amplifier is turned off, turn
down the volume or turn off the power of the woofer
otherwise, hum noise may be heard.
gi