Advertisement
CONNECTIONS
Connection of Speaker Cord
Strip off the vinyl coating and put the wire ends together.
Speaker (right)
Speaker (left)
impedance of Speaker System
Speaker systems with a nomina! impedance of 4 to 16 2 can be used
when systems A or B are used separately. Use nominal impedance of
8 to 32. when playing both systems simultaneously.
PANEL FACILITIES
Connection of Input.and Output Cords
* Connect white piug to "L" side and red plug to "R" side. Make
sure to insert them securely.
R
L
@ &
%
White plug
|
&
Red plug
*
Insert
the
pin
plug
of
the
connecting
cords
securely.
Incomplete plugging may result in noise or insufficient sound.
LINE VOLTAGE SELECTOR SWITCH
Mains voltages in Saudi Arabia are 127 V and 220 V only. Never use
this model with 110 V setting in Saudi Arabia.
Before your model is shipped from the factory, the switch is set to the
power requirements of the destination; nevertheless, you should check
that they are set properly before plugging the power cord into the AC
outlet.
1. Check the power cord disconnected.
2. Use a medium-size screwdriver.
3. Insert the screwdriver into the groove on the voltage selector, and
adjust so that the tip of the arrow points to the voltage value of your
area.
VOLTAGE SELECTOR
s20-127¥
10
240V
220v
Medium-size screwdriver
hn
See page 2 for location of Panel Facifities
REAR PANEL
\. AUDIO INPUT jacks
@ LASERDISC
Connect to the AUDIO jacks of a LD player.
m@YvCR
Connect to the AUDIO
OUT jacks of a VCR.
@ CABLE
For input of monophonic audio signals from cable receivers
etc, When both terminals are connected select 1 or 2 using
the sending device.
Mt TAPE/AUX
Can
be
connected
to the
PLAY
(OUTPUT)
jacks of a
cassette
deck
or to the OUTPUT
jacks of other
audio
components.
'2 VCR SOURCE
SELECTOR SENSITIVITY switch
Switch it for proper operation of the AUTO SOURCE SELECTOR
function of the SA-V210.
For the AUTO
SOURCE
SELECTOR
function, see page 6.
M>: Normal position
L:
(When no LASERDOISC signal is input.}
i "TAPE/AUX"
or "CABLE"
terminal
is automatically
selected even though VCR is being played , set to this
position "L" to select VCR.
4
<ARCII72>
En
H:
(When no LASERDISC signal is input.)
If "TAPE/AUX" or "CABLE" is not selected even though
VCR
finishes its playback,
set to this position
"H" to
select "TAPE/AUX"
or "CABLE."
3. VCR VGLUME control
Controls the volume of the VCR input terminals sound:
This control is normally centered
but should be adjusted in
accordance with the volume of the LASERDISC.
<4: VCR MODE switch
This
switch
is used
to
select
the
VCR
audio
modes
{MONO/STEREO}.
Connect a VCR with monophonic audio output either to "L" or
'R" AUDIO
INPUT jack and set this switch to "MONO."
i5) CABLE VOLUME contro!
Controls the volume of the CABLE
input terminals sound.
This contro! is normally centered but should be adjusted in
accordance with the volume of the LASERDISC.
© TAPE/AUX
SOURCE
SELECTOR
SENSITIVITY
switch
Switch
it for
proper
operation
of
the
AUTO
SOURCE
SELECTOR function of the SA-V210.
Advertisement
