Table of Contents
Advertisement
®
8
POWER SAVE
OFF: For normal VTR operation.
Characters appear o> the display even when the
VTR's power is off.
ON:
For operating the VTR in the power-saving
mode.
No characters appear on the display when the
VTR's power Is off
NICAM/MONO
NICAM:
Normally set at this position.
MONO:
Only set at this position to record the normal
sound during a NICAM broadcast or If the
stereo sound fs distorted due to_Inferior
reception conditions.
VAR+
To select the required programme position (TY
station).
To set the clock and timer recording.
CLOCK SET
To set the time.
SP/LP/NEXT
To select the tape speed required for recording.
SP gives the best picture quality.
LP gives the longest recording time.
Si
To proceed to the next
item during setting procedure.
TUNER PRESET
To initiate TV station settings for the tuner.
SLEEP/SHIFT
To set the time to turn off the VTR automaticall
To memorize programme position.
PROG/CHECK
To select a timer programme number.
"P1, P2, P3... or PB" is lit.
To display details of preset timer recording while the.
timer recording function is on,
TIMER REC
Ta turn the timer recording function on and off.
is it or not iit.
Once Operating timer recording function, the normal
VTR operation is not possible unless this button is set
to off.
REC
To start a recording.
RE OUT
To connect to the aerial terminal on a TV set.
TEST SIGNAL
The test signal is transmitted on channel 36. _.
Controls and Connection Sockets
@® av
This 21-pin scart terminal carries input and output
signals for both picture and sound. TV sets equipped
with a simiiar socket can be connected here.
This is also calied Scart
Peritei
Euro Connector
Euro AV
ast
BAA
Sett
Up
27
9
1 OEGG9085506\a
~
| 068665006 |
Pee
ewe
wee
1 AUIDO OUTPUT
8 SWITCHING
CH2(R)
VOLTAGE
2 AUDIO INPUT CH2(R) 17 VIDEO GROUND
3 AUDIO OUTPUT
19 VIDEO OUTPUT
CHI (L)
20 VIDEO INPUT
4 AUDIO GROUND
21 GROUND
6 AUDIO INPUT CHt (L)
Noconnection;
5.7.9, 10,11, 12.13, 14, 15, 16, 18
@ video ouT
To connect a video cable to a TV or another VTA.
oe
@ aupio ouT
Te connect a audio cable to a TV, another VTR or
stereo audio system.
@ AFIN
To connect to the external aerial.
@ LeveL
Used to adjust the UHF aerial signal strength.
HIGH: For normal position.
LOW:
If adiagonal pattern or stripes appear on the
picture.
@ cHADS.
To adjust the RF transmitting channel 30~42,
® acin~
To connect to the main power supply.
13
Advertisement
Table of Contents
