Toro 4045 Installation Instructions page 3

11. Install the guard assembly onto the frame
using 6 bolts (M8-1 1/4 x 35 mm).
12. Torque the bolts to 23 to 29 N-m (17 to 21 ft-lb).
13. Install the left guard assembly using 1 bolt (M8-1 1/4 x
30 mm), 1 locknut (M8), 1 Bolt (M12-1 3/4 x 120 mm),
and 1 locknut (M12) as shown in
Figure 4
1. Bolt (M12-1 3/4 x 120 mm) 4. Bolt (M8-1 1/4 x 30 mm)
2. Locknut (M8)
3. Left guard assembly
14. Torque the M8 bolts to 23 to 29 N-m (17 to 21 ft-lb).
15. Torque the M12 bolts to 80 to 100 N-m (59 to 73 ft-lb).
(Figure 2)
Figure 4.
5. Locknut (M12)
2
Installing the Right Guard
Brackets
Parts needed for this procedure:
1 Upper bracket, large
2 Bolt (M12-1 3/4 x 120 mm)
2 Locknut (M12)
1 Upper bracket, small
1 Lower bracket
4 Bolt (M8-1 1/4 x 30 mm)
4 Locknut (M8)
Procedure
1. Rotate the hydraulic lines as needed to ensure that they
do not rub on the stakedown guard assemblies
5).
1. Hydraulic fittings/lines
2. Install the upper support brackets as shown in
3
1
g0304 32
Figure 5
(Figure
Figure 6.