Memory Backup; Tuning Knob Steps - Yaesu FT-767GX Operating Manual

3.6 Memory Backup
Before leaving the factory, the lithium memory
backup system is switched off. Set this on by
pushing the BACKUP switch on the rear panel so
that it is in the out (undepressed) position.
This will allow VFO and memory data to be
retained while power is off. Backup current
is miniscule, so it is not necessary to turn
the BACKUP switch off unless you wish to
intentionally clear all memories, or if the
transceiver is to be stored for an extended
period,
After five or more years of operation the
transceiver may fail to retain memories, at
which time the lithium battery should be
replaced. Contact your dealer for replacement
of the battery.
FAS-1-4R
ant
COMPUTER
Ac coro
LINEAR AMP)
= qe
3.7 Tuning Knob Steps
The tuning knob rate is preset by switch
S3005 on the Local Unit for 5kHz per revolu-
tion (Fast 50kHz/rev).
To change this to 10kHz/100kHz per revolu-
tion, locate S3005 as shown below, and move
it to the 10kHz position.
lr
o
Doo d
oo,
[Ta
LOCAL UNIT
APPLE /FIF-65A
E