Filling With Water (For Steam Ironing); Operation - Matsui M120IR11E Instruction Manual

Filling with Water (for Steam Ironing)

1. Make sure the iron is unplugged from the mains
socket and the Steam Dial is at the "0" position.
2. Set the iron so that it is level, and fill the water
reservoir by pouring water in through the Water
Filling Inlet.
GB
3. Dry any water on the outside of the water reservoir,
and when finished ironing, empty the water
reservoir.
4. If you live in a hard water area, it is advisable to use
distilled or de-mineralised water. Avoid using water
containing softeners, perfumes or additives.
Do not fill the iron above the max mark indicated on the side of the iron.

Operation

• Ensure the mains socket is switched off and the
Steam Dial is at the "0" position.
• Fill the iron with water as described above.
• Place the iron on its heel on the ironing board rest
and connect the mains cable to the mains socket.
• The Temperature Indicator will illuminate.
• Select the correct temperature by turning the
Temperature Dial.
Turn clockwise to increase and anti-clockwise to reduce temperature.
• Some parts have been lightly greased and the iron might smoke slightly
when switched on for the first time. After a short while, this will cease. We
recommend passing the iron over a clean cotton cloth before using it for the
first time. The Temperature Indicator will go off when the indicated setting
reaches the correct temperature. The iron is now ready for use. During use
the indicator will light on and off as the thermostat maintains the iron at the
correct temperature setting.
• In between operations and when filling the iron always stand the iron on its
heel. NEVER leave the iron face down.
24
max
DECREASE INCREASE