Honeywell BENDIX/KING KAP 140 Maintenance Manual page 58

3.3.6 DISCRETE OUTPUTS SCREEN
Pressing 'O' when the Diagnostics Menu screen is displayed will cause the Discrete Outputs
Status screen, shown in Figure 3--7, to be displayed. Pressing the 'ENTER' key at this point will
return the user to the Diagnostics Menu screen.
FIGURE 3--7 NO TAG DISCRETE OUTPUTS SCREEN
This screen consists of FCC discrete outputs which can be manually activated and deactivated.
This is accomplished by entering the desired option number, for example '15' for Pitch Clutch. The
following message will appear.
Entering a '1' will activate the discrete output, and entering a '0' will deactivate it. The discrete
outputs will remain active even though the Discrete Outputs screen is exited but will automatically
deactivate if Diagnostics mode is exited.
ITEM
Audio Alert
Visual Alert
Roll Fail Annun, Pitch Fail Annun
AP Annunciator
Revision 2, Dec/2002
CS:15574F02
BENDIX/KING
KAP 140
System mode: Diagnostic
SET DISCRETE OUTPUTS
--------------------
(Enter 1 or 0 [0-7 for Audio Volume])
1 - Audio Alert
2 - Visual Alert
3 - Roll Fail Annunciator
4 - Pitch Fail Annunciator
5 - AP Annunciator
6 - Audio Volume
7 - PFT
8 - PFT Clear
9 - MET/PFT Up
10 - MET/PFT Down
11 - MET/PFT Arm
12 - Normal Acceleration Test 0
13 - PFT Pitch Clutch
14 - Roll Clutch
15 - Pitch Clutch
16 - Pitch Trim Clutch
Press key for desired option (<CR> to exit)
Enter value for Pitch Clutch
0
0
0
0
0
4
0
0
0
0
0
0
0
0
0
DESCRIPTION
A "1" on this output generates the AP disconnect
tone to the 500 ohm output and to the TONE_ALERT
output, used to drive an external sonalert.
A "1" on this output turns on an external AP DISC
annunciator.
A "1" on these outputs turns on the R or P LED axis
failure indicators on the FCC.
A "1" on this output "arms" the AP disconnect
alerting, causing a disconnect tone to be generated
when it is written to "0".
():
Page 3--14