Advertisement
@ DIRECT button"
Press this to listen to source sound without passing the audio
signal through sound quality and balance adjusting circuitry.
The surround mode, super bass, and rear and center speakers
are automatically switched off.
MULTI-JOG
Use during tuner operation to select freguencies and station
numbers. During GUI operation, use to move the on-screen cursor.
(9) GUI ENTER button (GUI operation)
Press to execute an operation selected with the MULTI-JOG.
MUTING button
Press to temporarily cut off the sound volume. When pressed
again, the sound will return to its previous level.
A) GUI MODE button
Switches GUI MODE on and off.
42 MASTER VOLUME control
Use it to simultaneously adjust the sound volume from the
front, center, and rear speakers.
(3 SLEEP button
Activates the SLEEP timer. The length changes in the
following manner each time the button is pressed:
Ea 90
—
60 —
30 MAS]
Unit: minutes
® PHONES jack
Connect the plug on your headphones to this jack. Set SPEAKERS
A and B switches to OFF if you want to cut the sound from the
Speakers and listen to it only through the headphones.
(5 VIDEO INPUT jacks
VIDEO components such as a VCR or TV camera, etc. can be
connected.
(6 SUPER BASS button*
Press this button when you want to boost the bass.
(2 Display section
TUNING MODE buttons
FM/AM button:
Use this to switch between FM and AM frequency band reception.
MPX MODE button:
Use to select the auto stereo mode or monaurai mode when
listening to FM broadcasts. The monaurai mode has been
selected when the MONO indicator in the display section is lit.
Auto stereo mode
Normally, leave in this mode for reception. When a stereo FM
broadcast is received, it will be automatically reproduced in stereo.
VSX-D704S,
VSX-79
Monaural mode
When receiving distant stations or stations with weak broadcast
signals, the input signal may be weak, thus resulting in increased
noise during FM stereo broadcasts. In this event, setting the receiver
to the monaural mode will reduce the noise. In this case, however,
FM stereo broadcasts will be reproduced in monaural sound.
NOTE:
This button has no effect on reception of AM broadcasts.
MEMORY button:
Press this button to switch to the freguency preset mode.
(When GUI is ON, it does not operate.)
ENTER button:
Press this button when you are in the freguency preset mode, and
the displayed freguency is memorized in the selected station.
(Station indications stop flashing and stay lit.)
(When GUI is ON, it does not operate.)
SELECT button:
Press this button to switch to the station mode. Then you
can turn the multi-jog to select a station.
(When GUI is ON, it does not operate.)
DOLBY PRO-LOGIC button*
Switches DOLBY PRO-LOGIC SURROUND on and off.
@ DSP MODE button"
Each time you press it, the mode and the display indications
change as follows.
Pa
—
DANCE
—+
SIMULATED SURROUND
off «— PRO-LOGIC THEATER «—
HALL
€) DOLBY 3CH LOGIC button"
Select this setting when stereo-source regeneration and rear
speakers are not connected and you wish to use the front L,
front R, and center speakers to enjoy audio/visual material
bearing the D(][petsy suraouno] mark.
22 BASS control
Use to adjust the low-freguency level. Turn clockwise to boost
bass, and counterclockwise to attenuate bass.
23 TREBLE control
Use to adjust the high-freguency level. Turn clockwise to
boost treble, and counterclockwise to attenuate treble.
@ BALANCE control
Use to adjust the sound volume balance between left and right
speakers.
L: Decreases the sound on the right side.
R: Decreases the sound on the left side.
Usually, left and right volume levels should be the same.
* Setting is memorized separately for each input selector
button.
75
Advertisement
