Table of Contents
Advertisement
Figure 11
P. HOUR METER
The hour meter is located on the instrument panel.
(See Figures 3 and 12.) It indicates the actual hours
of engine operation, enabling the operator to deter¬
mine without guesswork when lubrication, change of
oil or periodic inspections are necessary. It also pro¬
vides a means of computing cost of specific jobs.
The hour meter operates whenever the engine is run¬
ning or the ignition key is in the "ON" position.
Figure 12
Q. THROTTLE CONTROL LEVER
This lever controls the speed of the engine. When
set In a given position, it will maintain a uniform
engine speed. (See Figure 3.)
When using power take-off operated equipment, best
performance is achieved with the throttle lever in the
"FAST" position.
This symbol shows slow position.
This symbol shows fast position.
R. SPEED CONTROL LEVER
NOTE
Do not rest your foot on the single brake
pedal while driving the tractor as this would
cause the speed control lever to return to the
"N" position.
The lever is used to select any speed from a standstill
"N" position to eight miles per hour in the forward
direction and four miles per hour in the reverse direc¬
tion.
Moving the speed control lever forward provides
increased forward speed, and moving the lever rear¬
ward provides the reverse speeds. (See Figure 3.)
S. SPEED CONTROL STOP
An adjustable speed control stop is provided to allow
the operator to return to a predetermined speed.
(See Figure 3.)
T. FUEL TANK FILLER CAP GAUGE
The fuel tank filler cap gauge indicates how much fuel
is present in the fuel tank. It also works as the fuel
tank cap. Remove the fuel tank filler cap gauge to fill
the fuel tank. Reinstall filler cap after filling tank.
(See Figure 3.)
U. OIL INDICATOR LIGHT
Indicates oil pressure of engine.
NOTE
Oil indicator light will be on when engine is
started. (See Figure 3.)
FUEL SHUT-OFF VALVE
The fuel shut-off valve which is located below the
gasoline tank is used as a main fuel shut off to the
engine. To turn the fuel on, turn the knob counter¬
clockwise to the stop. To turn the fuel off, turn the
knob clockwise until it is tight.
HOOD AND NOISE ISOLATION PANELS
The tractor hood is arranged to swing up and forward
for easy access to the engine compartment. When¬
ever engine maintenance is required, the noise isola¬
tion panels can be readily removed by removing the
two wings nuts and two washers (one on each side)
and disconnecting the panel spring. (See Figure 13.)
Figure 13
1. Noise Isolation Panel (One On Each Side)
2. Panel Spring
3.
Hood
10
Advertisement
Table of Contents
