To Select Connected Equipment - Philips 32PW9588 Manual

Connect extra loudspeakers/amplifier
multimedia loudspeakers
REAR
&
Select
Surround speakers On
menu, see p. 8.
é
Connect the audio cables to the rear
loudspeakers and to the Dolby Surround
output
SURROUND OUT
TV. There is only one output for both
speakers.
"
Adjust the volume of the rear loudspeakers.
Use the Test tone function in the Speakers
menu, see p. 8.
Note: Once you have adjusted the volume of the
rear loudspeakers, do not change it while watching
TV as the whole configuration operates with the
volume adjustment of your TV.

To select connected equipment

Press the v key on the remote control repeatedly to select
according to where you connected your equipment at the back or the right side of your TV.
Remark : Most equipment (decoder, recorder) carries out the switching itself, when it is switched on.
Cinema Link surround receiver
See the separate supplied Cinema Link instruction manual.
Attention: the sound info on screen will not correspond with the actual sound reproduction.
Recorder or DVD with EasyLink
The recorder (VCR or DVD+R(W)) or DVD can
be operated with the remote control via the
or menu on screen.
Recorder
DVD
Recorder
Ò
Rwd Play
DVD
Ò p
Prev. Play
in the Setup
at the back of your
p ‡ π †
Stop Play Ffw
‡ π †
Stop Play Next Eject
(Analogue) Multichannel surround receiver
&
Connect a MultiChannel surround receiver to
the
back of your TV.
é
If you want the loudspeakers of your TV to act
as centre speaker, also connect an audiocable
to the MultiChannel surround receiver
CENTRE OUT
connector at the back of your TV.
IN
"
Select
See p. 10.The loudspeakers of the TV will now
only produce centre sound.
'
If necessary, adjust the volume level of the
centre sound in the
item of the Source menu.The overall volume
has to be controlled via the MultiChannel
surround receiver.
EXT1
&
Press the
é
Select the
cursor up/down.
"
Press the cursor left/right, up/down to select
®
Ï
one of the recorder or DVD functions.
Rec Eject
The key ® for recording can be operated in the TV
mode.
If your EasyLink recorder has the system standby
Ï
function, when you press the B key for 3 seconds,
both TV and the recorder are switched to standby.
and
AUDIO OUT R
connector and to the
Centre input On
Centre in volume
, , ,
EXT2 EXT3 EXT4
key on the remote control.
MENU
or
Recorder
connectors at the
L
CENTRE
in the Source menu.
menu
or
SIDE
menu with the
DVD
21