TurboChef 1618 Owner's Manual page 39

30 LEGACY CONTROLLER
Adjusting the Belt Speed
The oven can accommodate either one or two con-
veyor belts. The oven will automatically detect the
number of conveyor belts installed and display the
option to change the speed of each conveyor belt
independently.
1. From Figure 14, touch the soft key
adjacent to the conveyor belt you wish to
adjust (touch L2 for the front belt [Belt F]
or L3 for the rear belt [Belt R]).
2. Adjust the time it takes for the conveyor
belt to completely cycle through the oven.
- The up key increases bake time in
5-second increments up to 15 minutes.
+ Flex option enabled: the user can only
increase the time up to an additional
15 seconds.
- The down key decreases bake time in
5-second increments.
+ Flex option enabled: the user cannot
decrease the time by more than 15
seconds.
3. Touch the soft key adjacent to the belt that
was adjusted to exit the belt speed controls.
Adjusting the Temperature
1. Touch R2 (Figure 14, page 13) to access the
temperature controls.
2. Adjust the temperature (range is 300-550°F
[149-288°C]).
- Touch the up key to increase the temperature
in 5°F/5°C increments.
+ Flex option enabled: the user can only
increase the temperature up to an
additional 10°F/5°C.
- Touch the down key to decrease the
temperature in 5°F/°5C increments.
+ Flex option enabled: the user cannot
decrease the temperature by more than 10°
F/5°C.
3. Touch R2 again to exit temperature controls.
Adjusting the Top and Bottom Air
1. Touch R1 (Figure 14, page 13) to access the
top air controls, or R3 to access the bottom air
controls.
2. Adjust the air speed.
- Touch the up key to increase the air speed in 5%
increments up to 100%.
+Flex option enabled: the user can only
increase the air speed by up to an additional
15%.
- Touch the down key to decrease the air
speed in 5% increments down to 30%.
+Flex option enabled: the user cannot decrease
the air speed by more than 15%.
- Touch the soft key again to exit the air controls.
HCT- 4201 / Rev S / January 2024