Troubleshooting - Philips 32PF9431 User Manual

2564.1 en 04-09-2006
EN
Symptom
No picture
Poor picture
Poor colour
No sound
The remote does
not function
The remote of
connected equip-
ment does not
function well
No photo or music < Verify if the source complies with a supported code.
play or in poor
quality
No stable or not
synchronised VGA
picture
No solution found
for your picture or
sound problem
Red blinking led
46
14:19 Pagina 46

Troubleshooting

Possible cause/Remedy
< Verify if the supplied cables are connected properly. (The aerial cable to the
TV, the other aerial to your recorder, the power cables, ..)
< Verify if you selected the correct source.
< Verify if the child lock has been switched off.
< Verify in the Manual installation menu if you have selected the correct TV
system.
< Verify if your TV or house aerial isn't located too close to loudspeakers,
non-earthed audio equipment or neon lights, etc.
< Mountains or high buildings can cause double pictures or ghost images.
Sometimes you can improve the picture quality by changing the direction of
the aerial.
< Is the picture or teletext unrecognisable.Verify if you have entered the
correct frequency. See Installation, Manual installation, p. 23.
< Select Factory settings in the Installation menu.
< Verify the connections between the optional equipment and the TV.
< Verify if the volume isn't at minimum.
< Verify if the sound hasn't been muted with the ¬ key.
< Verify the connections between the optional equipment and the TV.
< Verify if the remote is set correctly for the equipment your are using.
< Verify if the batteries are not dead. Replace the batteries.
You can still use the keys at the right side of the TV.
< Select
TV mode on your remote control.
< When pressing a key and some key leds are blinking with a higher speed
and lower intensity than in a normal working condition, and your TV does
not react on the key press, remove the batteries out of the remote control
and put them back again.
< The infrared signals of the screen may influence the reception sensibility
of other peripherals.
Solution: replace the batteries of the remote of other peripheral equipment.
< Verify if you have selected the correct VGA mode in your PC.
See Connect a PC, p. 42.
< Verify the connections between the PC and the TV.
< Switch off your TV off and then on again once.
Never attempt to repair a defective TV yourself.
Verify with your dealer or call a TV technician.
< Unplug the mains cord for 10 seconds and insert it in again.