Table of Contents
Advertisement
Clearing Jams:
Should a fastener jam occur, disconnect air supply.
Features
Maintenance
read section titled "Safety Warnings" before using tool.
All screws should be kept tight. Loose screws result in unsafe operation and parts breakage.
With tool disconnected, make daily inspection to assure free movement of trigger. Do not use tool if trigger sticks or
binds.
Wipe tool clean daily and inspect for wear. Use non-flammable cleaning solutions only if necessary–DO nOt SOaK
Caution: Such solutions may damage O-rings and other tool parts.
no routine oiling necessary.
repairs other than those described here should be performed only by trained, qualified personnel. Contact SenCO
1
3
to adjust the depth the fastener is driven:
First disconnect the air supply.
Using your thumb or index finger, rotate wheel to adjust the Depth Control workpiece contact
(safety element) to achieve desired depth.
to adjust the direction of the exhaust air:
Turn the exhaust deflector to the desired location.
for information at 1-800-543-4596.
2
10
① Push latch and slide rail open.
② Remove fasteners.
③ Remove jammed fastener.
Advertisement
Table of Contents
