Table of Contents
Advertisement
4. Talking and monitoring
4.1 Answering doorphone calls
When you receive a call from a doorphone, the main
monitor, extension monitor, and sub monitor ring, and
display an image from the doorphone.
To answer the call
Press M
N.
R Speak within about 50 cm of the microphone.
R Speak alternatively with the visitor. If you and the
visitor speak at the same time, you will not hear each
other.
R You can talk for up to about 90 seconds.
To end the call
Press M
N.
Note:
R The display will turn off if you do not answer a call
within about 30 seconds.
R The displayed images are automatically recorded to
the main monitor (page 18).
Features available during incoming calls
– Monitoring feature (page 17)
Features available while talking
– Adjusting wide/zoom and pan/tilt settings
*1
(page 22)
– Turn on or off the operation guide (page 22)
– Adjusting sound and display settings (page 22)
– Using "press-to-talk" (page 16)
– Transferring calls to other devices (page 16)
*1 These functions are not available for the supplied
doorphone (VL-V522L). You can use these
functions with optional doorphones (page 4).
Press-to-talk mode
If it is difficult for you and the visitor to hear each other
due to noise, the "press-to-talk" mode can make
conversations easier to hear.
1. While talking, activate press-to-talk mode by
pressing and holding M
R A beep sounds and
2. To speak to the visitor
Speak while pressing and holding M
To listen to the visitor
Release M
N.
Note:
R Press-to-talk mode is cancelled when the call ends.
Voice answer mode (Answering a call by voice
sensor; sub monitor only)
This mode allows you to answer a call by voice without
pressing M
N on the sub monitor.
Voice answer must be set "ON" beforehand (page 26).
1. When a ringer tone is heard, answer with a clear
voice such as "Yes?" or "Hello?".
R When a beep sounds, you can talk to the visitor.
16
N for about 2 seconds.
is displayed.
N.
Note:
R Make sure you are within about 50 cm of the sub
monitor.
R The visitor cannot hear your initial reply when you
answer with voice.
R Your initial reply should be brief (less than 1 second),
otherwise the voice answer mode will not start.
R If a visitor calls you, a loud, brief sound (such as a
dog's bark) may start the voice answer mode even
though you have not replied by voice.
R When you locate the sub monitor near the main
monitor, the voice answer mode may be started by a
ringer tone.
R The voice answer mode is also available for paging
calls.
4.2 Transferring doorphone calls
You can transfer a doorphone call between the main
monitor, sub monitor, and extension monitor.
To transfer a call
1. While talking with the visitor at the doorphone, press
M
N. (M
N for the sub monitor.)
2. If there are multiple devices, select the device to
transfer the call to ®
monitor.)
R To page all devices, select "Call all
together" ®
the sub monitor.)
3. Page the other party.
4. When the paged party answers, ask them to receive
the call from the doorphone ® M
R To cancel transferring the call and talk to the
visitor again, press M
To receive a call
1. When the intercom call is received, press M
talk to the paging party.
2. When the image from the doorphone is displayed,
talk to the visitor.
3. When finished, press M
Note:
R The visitor cannot hear voices during paging.
R When using the sub monitor to transfer calls or
receive transferred calls, extension monitors are
displayed as sub monitors in the list of available
devices and for the device name of incoming calls.
For example, "Extension monitor 1" is
displayed as "SUB 1".
. (
(OK) for the sub
. ("ALL" ®
(OK) for
N.
N.
N to
N.
Advertisement
Table of Contents
