Connect Your Computer - Philips 32FD9954-69S Manual

1015.5 en 12-11-2003 11:12
L
R
RS232 DVI-D VGA 2
~ MAINS AUDIO
Pagina 1
m i n .
1 m
&
é
L
VGA 1
VGA 2 RC-OUT
VGA 1
R
VGA 1
DVI-D Y/C S-VHS AUDI
AV2
1
2
&
é
"
'
Unpacking and wall mounting instructions
For the unpacking instructions follow the illustrated steps printed on the
packaging (outside and inside). For the wall mounting instructions follow the
illustrated steps ' to § printed on the separate template and in the
supplied booklet.
Make sure that the wall mount is being fixed securely enough so that it meets
safety standards.The weight of the monitor (excl. packaging) is about 24 kg,
30 kg or 35.5 kg, depending on the screen size (32", 37" or 42").
Note: stands are optional acccessories. Consult your dealer.
To prevent any unsafe situations, no naked flame sources, such as lighted candles,
should be placed on or in the vicinity. Avoid heat, direct sunlight and exposure to
rain or water.
The equipment shall not be exposed to dripping or splashing and no objects filled
with liquids, such as vases, shall be placed on it.

Connect your computer

Directly to the monitor
Connect one end of a VGA cable 1 to the video card of the computer and
the other end to the connector at the rear side of the monitor. Fix the
VGA 1
connectors firmly with the screws on the plug.
In case of a Multimedia computer, connect the audio cable 2 to the audio
outputs of your Multimedia computer and to the
(left) inputs of the monitor.
L
VGA 2: The video connector for VGA 2 can be programmed to become an input or an
output via the Setup menu, see p. 6. The function of being input or output is
determined by the used mode. If the monitor is used in video mode, the VGA 2
connector is VGA output. If the monitor is used in monitor mode,the connector is VGA
input or output.
To a electronic receiver box
See the handbook of the receiver box.
Connect one end of a VGA cable to the video card of the computer and the
other end to the connector at the rear side of the receiver box.
PC/MAC IN
Fix the connectors firmly with the screws on the plug.
In case of a Multimedia computer, connect the audio cable to the audio
outputs of your Multimedia computer and to the
(left) inputs of the receiver box.
Note: Only use the VGA cable supplied with the monitor.
Daisy chaining
The Loop Through facility makes it possible to make a daisy chain with a
second monitor.
Connect one end of another VGA cable to the
side of the monitor and the other end to the
monitor.
In case of a Multimedia computer, also connect audio cables to the
and outputs of the original monitor and to the
R
second monitor.
The RC out jack next to the
VGA 2
remote control signals to other equipment.
This output cannot be used to daisy chain a second monitor.
AUDIO VGA 1 R
(right) and
AUDIO IN R
connector at the rear
VGA 2
connector of a second
VGA 1
and
AUDIO L R
connector makes it possible to daisy chain
(right) and
L
AUDIO L
inputs of the
1