Kenwood DPX-400 Instruction Manual page 37

'What might seem to b
PROBLEM
POSSIBLE CAUSE
SOLUTION
The power does not turn on
The fuse has blown
Teplace the
No ACC position on vehicle ignition
Wo sound can ba heard, or he
volume i low.
"Attenuator is turned on
Tum off Ateruntor
Reset the fader or balance settings,
The inputloutput wives oF wing harness are connected
sneorrectly
Try playing another cassort
tape was bad
'ap8. works fine, the fst
The tape does not pon 7
'No sound can be heard even
though the tape splay is
mode.
Press t h e Eject button
Nothing happens when the
buttons ae pressed.
The tape heads diy,
(Check the speaker wiring.
The speakers are not wired correctly
Radio reception fs poor
—37—