Table of Contents
Advertisement
ENGINE REMOVAL
If the engine is removed from the tractor the following
steps should be followed for the removal and installation of
the engine.
REMOVAL
1. Follow the steps to remove the Power Take Off belts
shown in Fig. 6.
2. Remove the four engine bolts holding the engine to the
frame of the tractor.
3. Remove the hood brace from the front grille to the dash
board.
4. Remove the three wires to the starter-generator (red wire
to the L.H. terminal and small black wire and large black
wire to the R.H. terminal).
5. Shut off the gas valve and disconnect the gas hose.
6. Disconnect the throttle and choke wires to the engine.
7. Lift out the engine.
INSTALLATION
1. Set the engine in position and tighten the four engine
bolts finger tight.
2. Attach the Power Take Off belts, (see Fig. 6)
3. Assemble yoke to clutch plate with three bolts.
4. Attach hood brace and wiring.
5. Attach choke and throttle wires to engine.
6. Attach gas line and open valve.
7. Tighten engine bolts.
8. If vibration occures, loosen the four bolts holding the
Right Angle Drive Bracket to the frame (see Fig. 17),
disconnect the spark plug wire, and while the engine Is
cr'anking, tighten the four bolts holding the Right Angle
Drive Bracket. This is covered in detail in the Drive Train
Removal Section of this manual.
CLUTCH ASSEMBLY
ELASTIC STOP NUT
FIG. 17
-
11
-
Advertisement
Table of Contents
