Kenwood KR-300HT Instruction Manual page 28

KR-GOOHT [En/K}
"Unplug the AC power plug from the wall outlet.
Amplifier
Sound is not output or the volume level is
low.
The STANDBY indicator blinks and sound is
not output.
Sound is not output from one of the speak-
ers.
Sound is not output from the surround
speaker and/or center speaker, or their sound
is very small.
A hum noise is generated when the PHONO
input is selected.
System control is not available when TAPE1
or MD is selected.
System control is not available.
Display is dimly let.
Radic stations cannot be received.
Interference.
A station which was preset cannot be re-
ceived by pressing the corresponding mu-
meric key.
a
2While holding the POWER switch depressed, plug the AC
plug into the power outlet.
@Please note that resetting the microcomputer clears the contents
stored in and returns to the condition when it left the factory
e The speaker cords are disconnected.
@ MUTE is ON
(The MUTE ON indicator is blinking}
@ The SPEAKERS keys are set to OFF.
@ The TAPE 2 MONITOR key is set to ON.
e Speaker cords are short-circuited.
e@ The speaker cord is disconnected.
@ the BALANCE control is set to an extreme
position.
e The surround speaker cords and/or center speaker
cord are disconnected.
@ The Surround play mode has not been engaged.
e Thesurround andcenter speaker levels are set to
the minimum positions.
@ The audio cord from the turntable 's not inserted
securely into the PHONO jacks.
@ The turntable is not grounded
e "TAPE1" of "MD" Is not displayed.
@ The XS8 and SL16 modes were switched while
the AC plug is left plugged into the wali power
outlet
e The setting 's not correct
e@ No antenna is connected.
e@ The broadcast band ts not set properly.
@ The frequency of the desired station isnot tuned.
e@ Noise due to ignition noise of an automobile.
@ Noise due to an influence from an electric appli-
ance,
@ Noise due to a nearby TV set.
e The preset station belongs to a frequency that
cannot be received.
e The preset memory was cleared because the
power cord had been unplugged for a lang period
of time.
e@ The TUNER input is not delected.
BSE ESSE SEARS SRST RRR aa
e Connect them property referring to "Connec-
tion of speakers". 6
e Press the MUTE key to OFF.
@ Set the SPEAKERS key to ON.
eSet the TAPE 2 MONITOR key to OFF.
Set the input selector to the position other than
tuner.
@ Turn the power off, eliminate the short-circuit-
ing, then turn on the power again. 6.
@ Connect it properly referring to "Connection of
speakers", a
@ Adjust the Left/Right balance.
@ Connect them properly referring to "Connec-
tion of speakers". -(Lé.
e Set the presence mode. (22.
e Adjust the surround and center speaker levels.
elnsen the audio cord plugs securely into the
PHONO Jacks. | 4
e@ Connect the grounding wire to the GND term:
nai on the rear panel,
e Switch the display to TAPE 1orMD.-
(ee
e@ Unplug the AC piug from the wall outlet and
switch the XS8 or SL16 mode as required. _
5.
e Connect an antenna.
@ Set the broadcast band properly.
einstall the outdoor antenna away from the
road.
e@ Turn off the power to the appliance.
elnstall the system farther away from the TV
sét.
e Preset a station with a receivable frequency.
(12.
(19
e@ Preset the station again.
@ Select the TUNER input