Kenwood KR-300HT Instruction Manual page 12

Turn the power ON.
A-SPEAKERS-B
Play the selected source.
5 | Adjust the volume.
VOLUME CONTROL
(CY)
To decrease To increase
volume oown UP volume
B can be switched by operating the SPEAKERS A and
B keys as described below.
For the speaker connection method: ~ 6
e3 The sound output from SPEAKERS A and SPEAKERS
Note
A, BOFF . The speakers do not output sound. Use this position when
listening sound through headphones, etc.
AON : The speakers connected to the SPEAKERS A terminals on
the rear panel output sound.
A OFF : The speakers connected to SPEAKERS A, center speaker
and sub-woofer do not output sound.
BON : The speakers connected to the SPEAKERS B terminals on
the rear panel output sound.
A,BON_ . The speakers connected to the SPEAKERS A and B termi-
nals on the rear panei output sound simultaneously.
e When the surround mode is entered while both SPEAKERS A and B are
ON, SPEAKERS B are turned OFF automatically.
If the SPEAKERS 8 key 's pressed at this time, SPEAKERS B are turned
ON, and the surround mode is canceled.
eVWhen the surround mode is entered while SPEAKERS B are ON,
SPEAKERS 8B are turned OFF automatically, SPEAKERS A are turned
ON and surround play starts.
The input sources are switched in the following order:
"TUNER (frequency display)
The selected source ts
(2) PHONO displayed.
@ VIDEO1 (TAPE 1 or MD)*! :
CD
&:VIDEO2 ~ 7
@®AV AUX | La
SS 4
1: Switching the VIDEO1 display to TAPE1 or MD display
When a KENWOOD cassette deck or MD recorder 1s connected in the
[SL16] system controi mode, the VIDEO 1 input should be switched to .
the TAPE1 or MD input with the following operation.
QSelect VIDEO1 with the INPUT SELECTOR. . eg
Note
@Press and hold the AUTO key for more than 2
seconds to select TAPE1 or MD.
Volume level is displayed
ie a 1 TI i
! ed 7
: ¥oLIkL
riut
@ The time taken till the volume level is displayed is variable depending
on the current operating condition.
e Rotating the VOLUME CONTROL at a higher speed increases the
amount of volume change (Al VOLUME function).
@The sound of input source cannot be listened to while TAPE 2
MONITOR is ON.