Speaker Terminals - Pyramid ARCTIC Series Owner's Manual

FUNCTIONS PB-101/PB-251
1. POWER ON LED
Lights up when the remote on system is energized.
2. LOW LEVEL INPUT (HIGH IMPEDANCE)
This unit is provided with gold plated RCA input Jacks for High impedance in-
put. Couple the RCA input with the car stereo output using RCA type connector
cables.
3. GAIN CONTROL
Adjusting the control will match the output of the stereo to the amplifier. Turn
the control clockwise for more volume and counter-clockwise for less volume.
If there is distortion when the volume of stereo is turned up, turn the control down.
4. HIGH LEVEL INPUT (LOW IMPEDANCE)
If your car stereo does not have RCA output jacks, you can connect the speaker
output from the stereo system to the amplifier.
5. POWER SUPPLY
A. +12V
To connect +12V DC power supply wire from the terminal of the battery.
B. GROUND
To connect the ground wire from the chassis of the automobile.
C. REMOTE
To connect the control wire which provides remote turn on and off of the
amplifier by the radio/cassette player. (Usually The Auto Antenna Lead)
6. POWER FUSE
The power fuse protects both this amplifier and the automobile electricla system
from short circuit conditions.
7. SPEAKER TERMINALS
The speaker terminals are 14K Gold Plated for high conductivity and minimum
impedance loss. The terminals are facing upwards for easy wiring in tight situa-
tions. Be sure to strip just enough insulation off your speaker wires that will fit
under the screw plate to help ensure against speaker wire short circuit.