Description Of The Appliance; Assembly; Start Up - Kärcher KHP 3 Manual

Description of the Appliance

The scope of delivery of the device (depending on the
model) is illustrated on the packaging. These operating
instructions describe all possible options.
Illustrations on Page 2
1 Coupling element for water connection
2 Water connection with integrated sieve
3 Quick coupling for high pressure hose
4 High pressure connection
5 Appliance switch „0/OFF" / „I/ON"
6 Detergent Tank
7 Locking cap for detergent tank
8 Storage for trigger gun
9 Transport handle
10 Net for accessory compartment
11 Mains cable with mains plug
12 Bearing wheel
13 Trigger gun
14 Lock trigger gun
15 High pressure hose
16 Key to detach the high pressure hose from the trig-
ger gun
17 Spray lance with Dirtblaster
For strong contaminations.
18 Spray lance with pressure regulation (Vario Power)
Carrying out the most common cleaning tasks.
The working pressure can be continuously in-
creased from "SOFT" to "HARD". To adjust the
working pressure, release the trigger gun lever and
turn the spray lance to the desired position.
Suitable for use with detergents.
Additionally required
Fabric-reinforced water hose with commercially
available coupling.
– Minimum diameter, 1/2 inches (13 mm).
– Minimum length 7.5 m.
10
Mount loose parts delivered with appliance prior to start-
up.
Illustrations on Page 3
Illustration
 Push the wheels into the intake.
 Secure the wheels using the included plug. Align
the plug properly!
Illustration
 Insert the transport handle and screw in.
Illustration
 Lock the detergent tank in place on the appliance.
 Close the detergent tank with the lid.
Illustration
 Insert holder for trigger gun.
Illustration
 Fasten the quick coupling for the high pressure
hose to the high pressure connection.
Illustration
 Screw the coupling element to the water connec-
tion on the appliance.
Illustration
 Push the high pressure hose into the trigger gun
until it locks audibly.
Note: Make sure the connection nipple is aligned
correctly.
 Check the secure connection by pulling on the high
pressure hose.
 Park the appliance on an even surface.
Illustration
 Push the high pressure hose into the quick cou-
pling until it locks audibly.
Note: Make sure the connection nipple is aligned
correctly.
Check the secure connection by pulling on the high
pressure hose.
 Insert the mains plug into the socket.
For connection values, see type plate/technical data.
Observe regulations of water supplier.
ATTENTION
Impurities in the water can damage the high-pressure
pump and the accessories. For protection, the use of
the KÄRCHER water filter (optional accessory, order
no. 4.730-059) is recommended.
Illustration
 Attach the water supply hose to the coupling on the
water connection.
 Connect the water supply hose to the water supply.
 Completely open the water tap.
– 5
EN

Assembly

Start up

Water supply